Nexel HC1836HP Instruction Manual

US: 800-245-6682
México: 01.800.681.6940
Canada: 888-645-2986
WARNING:
Please read all instructions before using this unit and
save for future reference. Follow all food safety guidelines
and use caution when unit is on. If any damage is found,
do not attempt to operate the unit. Call Global Industrial
(1-888-628-3466) for assistance. Only professional food
(800-245-6682) for assistance
service agents should attempt to service, repair or replace
electrical components, wiring or power cord.
IMPORTANT!
This cabinet is NOT a cooking appliance. It is for hot
food holding applications only. This unit will hold hot
food at a constant temperature and supply humidity for
proofing when the application applies. Food must be at
the appropriate temperature before being placed into the
cabinet. Pre-heat the cabinet to the desired temperature
before placing cooked, hot food into the cabinet. Use
a food probe to check internal food temperature – the
cabinet temperature is not necessarily the internal food
temperature. This is not a re-thermalizing cabinet. Water
pan must be in place during module operation.
CAUTION:
Unplug cabinet from wall and allow unit to cool before
cleaning or servicing. To clean the cabinet, wipe with a
damp cloth and dry with a towel. Use only cleaning agents
approved for aluminum. Do not wash the cabinet with
a water jet or high pressure water. Do not spray or pour
water into the module. Water dripping onto the floor from
open doors can be a slip hazard. Liability for improper or
careless use is the responsibility of the equipment owner or
persons servicing the unit, including the authorized service
agent. Keep cabinet and module clean. Accumulation of
grease and other drippings may ignite.
GENERAL
The heater/proofer is an aluminum transport cabinet with
heaters to function as a hot food holding cabinet, and/or as
a proofing cabinet.
The heater, or heat drawer, is slid into place on the lower
ledges of the cabinet. An electrical power cord is provided
and plugged into the drawer through an access hole into
the back of the cabinet. The main power switch on the front
of the drawer, when switched ON, will turn on the light in
the switch and turn on the air circulating fan in the drawer.
The circulating fan and 1500w heater element will operate
continuously while the unit is ON.
The thermostat control knobs are mounted to the left
and right of the HEAT/PROOF switch. The left thermostat
knob controls the heat in the cabinet from 1 (approx. 30%
relative humidity) to 9 (100% relative humidity). Average
setting is 6 (approx. 85% relative humidity).
Non-Insulated
Heater/Proofer
Call Nexel Industries Inc
1
nexelwire.com
Instruction Manual
HC1836HP(242947)
Model 242947
060117