Summary of Contents for impact SL190
- Page 1 Penetrometer SL190 Impact Test Equipment Ltd www.impact-test.co.uk & www.impact-test.com User Guide User Guide...
- Page 2 Impact Test Equipment Ltd. Building 21 Stevenston Ind. Est. Stevenston Ayrshire KA20 3LR T: 01294 602626 F: 01294 461168 E: sales@impact-test.co.uk Test Equipment Web Site www.impact-test.co.uk Test Sieves & Accessories Web Site www.impact-test.com...
- Page 3 OPERATING MANUAL STANDARD PENETROMETER MANUAL CODE: SL190 DO NOT TRY TO OPERATE THIS APPLIANCE BEFORE READING AND LEARNING THIS MANUAL IN ALL ITS PARTS GENERAL INDEX Chapter 1 GENERAL INFORMATION GENERAL INFORMATION IDENTIFICATION APPLICATIONS STRUCTURE AND OPERATING OF THE MACHINE...
-
Page 4: Maintenance
LIFTING UNPACKING INSTALLATION Chapter 4 MACHINE FEATURES DIMENSIONS AND MASS CALIBRATION Chapter 5 OPERATOR’S INTERFACE CONTROLS AND MESSAGES Chapter 6 WARNINGS SPECIMEN POSITIONING TRIAL START EXAMPLE OF OPERATING Chapter 7 MAINTENANCE STANDARD MAINTENANCE SPECIAL MAINTENANCE Chapter 8 DIAGNOSIS DIAGNOSIS Chapter 9 SCRAPPING SETTING ASIDE SCRAPPING... -
Page 5: Manufacturer Identification
It shows the procedures that can damage seriously the machine if they are not ATTENTION followed carefully It shows the procedures that can be dangerous to the operator if they are not DANGER followed carefully IDENTIFICATION MANUFACTURER IDENTIFICATION: See the cover page MACHINE IDENTIFICATION: See the plate on the machine where the complete identification data are to be found. - Page 6 • The manufacturer recommends following carefully the instructions and procedures of the operating manual and the safety standards concerning the safety devices and the general rules of the work environment. • Verify the accordance of the machine to the standards in force in the State where the machine has to be installed.
-
Page 7: Installation
The appliance doesn’t produce any noise. ATTENTION The indicated levels of noise are not necessarily safety levels for the operator. The exposure level of the operator are obviously related to the emission levels of the appliance, but other factors influence the exposure levels as the time of exposure, the environment, other appliances installed near to the appliance etc. -
Page 8: Machine Features
Chapter 4 MACHINE FEATURES DIMENSIONS AND MASS SL190 LENGHT 280 mm WIDTH 250 mm 530 mm HEIGHT 11 kg abt. MASS CALIBRATION The appliance is checked and calibrated in the factory using sample instruments periodically control by Official Calibration Institutes. - Page 9 VERTICAL ROD ROD POINTER SAMPLE BRASS CUPS SLIDER It allows the penetration made by a needle or a cone, inside the specimen. BUTTON By keeping the button pushed, the slider is free to move granting an easy positioning of the same. This allows its free fall.
- Page 10 Before starting the normal use of the equipment it is recommended to verify that it is in good working conditions with no defective or damaged parts. If necessary proceed with the required maintenance operations. SPECIMEN POSITIONING Put the material in the special sample cup and then position it on the machine base table. TRIAL STARTING Before beginning the standard use of this machine, check its perfect working conditions by carrying out at least one complete empty cycle.
- Page 11 DANGER All the maintenance operations must be carried out with the machine turned off and unplugged from the knife switch. DANGER Any kind of maintenance operations concerning the components of the machine and of the electric components, even those which may seem very simple, must be carried by skilled operators instructed about the purposes the machine is made for.
-
Page 12: Details Of The Appliance
ENCLOSURE B DETAILS OF THE APPLIANCE... - Page 13 •...
Need help?
Do you have a question about the SL190 and is the answer not in the manual?
Questions and answers