Advertisement
ASSEMBLY INSTRUCTIONS FOR C-8275 LAT/ROW MACHINE
THIS UNIT IS BULKY, HENCE REQUIRES TWO PEOPLE TO ASSEMBLE.
THIS UNIT REQUIRES (1) 9/16 WRENCH AND (1) 11/16" WRENCH FOR ASSEMBLY. DO NOT TIGHTEN
HARDWARE UNTIL INSTRUCTED.
STEP 1: PUSH (4) 2 X 2 OUTSIDE CAPS ONTO BASE.
ATTACH FRONT AND REAR BEAMS TO THE
BASE WITH (4) 3/8" X 3" HEX BOLTS, (8) 3/8" FLAT WASHERS AND (4) 3/8" LOCK NUTS
STEP 2: ATTACH FRONT & REAR UPRIGHTS TO THE BASE WITH (4) 3/8" X 3" HEX BOLTS, (8) 3/8"
FLAT WASHERS AND (4) 3/8" LOCK NUTS.
CAUTION: THE BASE HAS (6) HOLES. THE TWO HOLES CLOSE TO AN END MUST BE ATTACHED TO
THE REAR CROSS BEAM.
STEP 3: ATTACH SEAT MOUNT TO THE FRONT UPRIGHT AND BASE WITH (4) 3/8" X 3" HEX BOLTS,
(8) 3/8" FLAT WASHERS AND (4) 3/8" LOCK NUTS
STEP 4: INSTALL CARRIAGE BY INSERTING FROM THE TOP OF THE REAR UPRIGHT. MAKE SURE
THE PLATE HOLDER IS FACING FRONT
STEP 5: PLACE THE PRE-ASSEMBLED TOP FRAME ONTO TWO UPRIGHTS, (CABLE STOPPER BUSH
ASSEMBLY MUST FACE UPWARDS SO THAT THE CABLE WILL MOVE BETWEEN FRONT PULLEY AND
THE CABLE STOPPER) ALIGN THE HOLES AND ATTACH WITH (2) 3/8" X 3" HEX BOLTS, (4) 3/8" FLAT
(DETAILED INSTRUCTIONS GIVEN IN NEXT PAGE)
WASHERS AND (2) 3/8" LOCK NUTS
STEP 6: PLACE 3.5" PULLEY INSIDE THE BRACKET OF FRONT CROSS BEAM AND ASSEMBLE WITH
(1) 3/8" X 2 ½"HEX BOLT WITH (2) 3/8" FLAT WASHERS AND (1) 3/8" LOCK NUT.
STEP 7: ATTACH SEAT TO THE SEAT MOUNT BY USING (2) 3/8" X 1 1/4" HEX BOLTS WITH (2) 3/8"
FLAT WASHERS.
STEP 8: ATTACH THE UPPER CABLE TO THE CARRIAGE THROUGH TOP TWO PULLEYS AS SHOWN.
STEP 9: ATTACH KNEE CATCH TO THE FRONT UPRIGHT WITH 18" LONG 1" TUBE, (2) 4 X 8 ROUND
FOAM PADS AND (2) END CAPS.
STEP 10: CHECK THE UNIT ON A LEVEL SURFACE BEFORE TIGHTENING ALL BOLTS AND NUTS.
MAKE SURE THE PULLEYS ROTATE FREELY WITHOUT ANY RESISTANCE DUE TO THE OVER
TIGHTNESS.
HARDWARE LIST:
2 - 3/8" X 1 1/4" HEX BOLTS (FOR SEAT)
17 - 3/8" X 3" HEX BOLTS
1 - 3/8" X 2 ½" HEX BOLT ( FOR FRONT LOWER PULLEY)
18 - 3/8" LOCK NUTS
38 - 3/8" FLAT WASHERS
4 - OUTSIDE CAPS
1 - SEAT
2 - 1" END CAPS
2 - 4 X 8 FOAM PADS
3 - 3 ½"PULLEYS (TWO ASSEMBLED)
Page 4 of 5
Advertisement
