Download Print this page

Okayo C 8812 Operating Instructions

Tour guide system transmitter & lapel mic receiver & earphone 2 way charging dock

Advertisement

Quick Links

Okayo Tour Guide System
Power/Signal Indicator Guide
Indicator Behaviour
Red
Flash
Blue
Red
Steady
Blue
IMPORTANT
Maintenance / Operation Guidelines
Avoid excessive heat: Do not leave transmitters or receivers in direct sun for extended periods, in front of heaters
or any source of high temperature.
Avoid rough handling: Transmitter or receiver may be damaged if dropped.
Remove batteries: Remove batteries from transmitters and receivers when not in use.
Replace batteries: Ensure replacement batteries are the same or equivalent to existing. Batteries may explode
under charge or unit may malfunction if incorrect batteries are used.
Battery terminals: Ensure battery contacts are clean and free of corrosion before operation. If corrosion occurs it
could be a sign of faulty batteries. Return to your place of purchase if service is required.
Transmitter
Receiver
Low battery & sync
-
activated
Sufficient battery &
-
sync activated.
Low battery
Low battery
Sufficient battery
Sufficient battery
Tour Guide System

Operating Instructions

C 8810
C 8812
C 8813
C 8810
Okayo Tour Guide System
Transmitter & Lapel Mic
Receiver & Earphone
2 Way Charging Dock
C 8812

Advertisement

loading
Need help?

Need help?

Do you have a question about the C 8812 and is the answer not in the manual?

Questions and answers

Summary of Contents for Okayo C 8812

  • Page 1: Operating Instructions

    Okayo Tour Guide System Okayo Tour Guide System Power/Signal Indicator Guide Tour Guide System Indicator Behaviour Transmitter Receiver Operating Instructions Low battery & sync activated C 8810 Transmitter & Lapel Mic Flash C 8812 Receiver & Earphone Sufficient battery &...
  • Page 2 • 60 channels in the 520-544MHz frequency range. • Transmitter & receivers fitted with belt/pocket clip. • Clear and noise free reception. C 8810 Transmitter - Figure 1 C 8812 Receiver - Figure 2 Operation Channel synchronization Power on/off 1. Press mute/sync button on the transmitter before it is turned on.

This manual is also suitable for:

C 8810C 8813