Sony HDW-M2000 Operation Manual page 110

Menu items in the range 100 to 199, relating to the control panels (Continued)
Item number Item name
108 AUTO EE SELECT
109 FORCED EE WHEN
TAPE UNTHREAD
111 TSO PLAY
116 JOG DIAL RESPONSE
117 CONTROL PANEL
SELECTION
a)
Speed
TYPE 2
FWD
+3
(reverse)
+1
Rotation rate
RVS
FWD
-1
(forward)
-3
RVS
Settings
When a cassette is inserted and the function menu item PB/EE is set to EE,
select the VTR modes in which input video and audio signals are automatically
handled in E-E mode.
S/F/R : In STOP/EJECT/F.FWD/REW modes
STOP: In STOP/EJECT modes
During tape threading and unthreading, and when no cassette is inserted, select
whether the setting of the function menu item PB/EE controls the PB/EE setting
for output signals.
OFF : Control by the function menu item PB/EE
ON : No control (always E-E signal)
Select whether or not to enable tape speed override mode.
DIS : Disable tape speed override mode.
TSO: Enable tape speed override mode.
Select the tape speed characteristics for the search dial rotation rate (VTR
commands).
TYPE1 : Tape speed varies linearly over the range –1 to +1.
TYPE2: Tape speed varies stepwise as shown in figure
to +3. (Characterized by a zone around –1 and +1 where the tape speed is
independent of the search dial rotation rate. When playing back an HDCAM
tape, however, tape speed characteristic TYPE 4 applies.)
TYPE3: Tape speed varies linearly over the range –3 to +3, as shown in figure
below.
TYPE4: Tape speed varies stepwise as shown in figure
to +2. (Characterized by a zone around –1 and +1 where the tape speed is
independent of the search dial rotation rate)
Select the control panel function when the PANEL SELECT switch on the switch
panel is set to REAR.
SW : Only the control panel connected to the CONTROL PANEL connector on
the connector panel functions.
PARA : The control panels connected to the CONTROL PANEL connectors on
the switch panel and connector panel both function.
b)
Speed
TYPE 3
FWD
+3
Rotation rate
RVS
FWD
-3
RVS
c)
Speed
TYPE 4
FWD
+2
+1
Rotation rate
RVS
FWD
-1
-2
RVS
Chapter 10 Setup Menus
a) below over the range –3
b)
c)
below over the range –2
(Continued)
10-11