Page 1
16000-SIII RADIO:99903609: 20040405 16000-SIII Radio Remote Manual IOWA MOLD TOOLING CO., INC. BOX 189, GARNER, IA 50438-0189 TEL: 641-923-3711 MANUAL PART NUMBER 99903609...
Receiver MODEL AND SERIAL NUMBERS When contacting your dealer or IMT about service, repair or replaacement parts, know the model and serial numbers of the transmitter and receiver. The numbers are located on the label that is affixed to...
THEORY OF OPERATION may void the warranty. IMT disclaims liability for any claims or damages, whether warranty, property The BMS System includes a transmitter and a receiver.
OPERATION AND WORK AREA SAFETY GL-2 The work area must be free from obstacles, debris or Emergency Stop other tripping hazards. Avoid uneven work areas and Pushbutton any rough terrain. Always be sure of your footing. Be aware of overhead obstacles that may interfere with machine operation.
The receiver wiring is critical for proper system Antenna must be operation. Make all connections with good quality vertical (pointing up). contacts or solder joints to ensure proper electrical Area must be contact. free of obstructions Supply voltage and ground wiring are crucial and must be connected to reliable connecting circuitry.
Nova 1. Insert the battery with both guide pins in the 1. Insert the battery with both guide bars on the corresponding guide bars of the battery lower side of the battery in the corresponding compartment. guide slots of the battery compartment. 2.
Replace immediately with only transmitter drawing for additional information on the authorized parts. Contact IMT or your Dealer. arrangement of the transmitter’s operating elements and their corresponding functions. The following START-UP PROCEDURE...
The proportional functions and speed ranges are transmitter is not attached to the operator, the key pre-set by IMT according to the valve types. Your switch should be removed and stored in a secure dealer can refer to the basic adjustments at any time.
LED should stop flashing or go off. If the LED stays lit, there is a malfunction in the system. Contact your Dealer or IMT for repairs. Unauthorized entry into the receiver could result in damage to equipment and may void...
MAINTENANCE The owner of this radio remote control system must have the system inspected by a qualified technician at least once every year. A qualified technician has professional training, experience and extensive knowledge in wireless transmission of control signals. This includes familiarity with normal regulations for safe working conditions, accident prevention, guidelines and general BCH_0010...
If the system does not operate after normal start-up as If the system will not respond to the steps below or the described in Operation Section of this manual, follow LEDs indicate a failure, contact the IMT Service the recommended troubleshooting sequence to help Department or your authorized dealer.
SPECIFICATIONS Model Current rating, approx. 83 mA Transmission (Baseboard Module System) GL - Dimensions (with 300 mm x 180 mm x 180 mm System GA 610 protection frame) General Data GL - Weight (including 2.4 Kg battery and belt) Frequency 70 cm Band (Selectable 458.800 Mhz to 459.175 Nova - Dimensions (with...
Page 14
IOWA MOLD TOOLING CO., INC. BOX 189, GARNER, IA 50438-0189 TEL: 641-923-3711 MANUAL PART NUMBER 99903609...