Advertisement
Quick Links
Remote Movement Sensor
Ceiling Mounted
Product Data
Catalogue Number:
Supply Voltage:
Maximum Load:
Dimensions (mm):
Fixing method:
Lux Level Adjustment:
Timer Control Adjustment:
Detector Range:
Conformance:
Beam Patterns:
CEMS 040.0 No. 22 ISSUE 1 – 11/99
PIR/CM
9 - 16Vd.c. (12V nominal)
No Alarm State 14mA (12V nominal)
Alarm State
11mA (12V nominal)
80mm x 29mm
Surface mounting only - 4 x 4mm fixing holes
Install using supplied fixings
(UsingBW2/C controller only)
Located within IRS1 or BW2/C controller
Ceiling Height of 2.4m = 10m
Ceiling Height of 3.0m = 11m
Ceiling Height of 4.0m = 12m
EMC - 89/336/EEC
LVD - 73/23/EEC
Page 1
Advertisement
Summary of Contents for Chalmor PIR/CM
- Page 1 Remote Movement Sensor Ceiling Mounted Product Data Catalogue Number: PIR/CM Supply Voltage: 9 - 16Vd.c. (12V nominal) Maximum Load: No Alarm State 14mA (12V nominal) Alarm State 11mA (12V nominal) 80mm x 29mm Dimensions (mm): Fixing method: Surface mounting only - 4 x 4mm fixing holes...
- Page 2 Install a suitable ELV 4 core cable between the PIR/CM sensor and the IRS1/C or BW2/C controller. The cable is to be either installed in a suitable enclosure or clipped direct to the surface using a staple or clip. The cable insulation must be rated to the maximum voltage present in the system.
- Page 3 Wiring Diagram The diagram below shows the connection details for a PIR/CM detector. 1 to 4 detectors may be specified. The number of detectors is subject to the type of controller specified. IRS2/C controller = 1-4 detectors IRS1/C controller = 1 or 2 detectors Where lux level control has been specified then it is recommended that the first detector be the PIR/CM/LDR and the remainder be PIR/CM detectors.