Cardiosoft/Cs Connection And Setup - GE T2100-ST1 Service Manual

9.
10.
11.

CardioSoft/CS connection and setup:

To communicate to the T2100-ST1 or T2100-ST2 treadmill using
the USB port, you will need to install the appropriate USB driver
software on your host computer. The USB driver is supplied on
the provided flash drive. When connecting to the USB port,
ensure port configuration is congruent with your software port
identification.
First Time Installation of the Serial Driver Software on the
CardioSoft/CS PC
This section installs the USB Serial Driver on the PC which has the
CardioSoft or CS application installed.
2097937-002 Rev G
11 March 2019
The COM port number is displayed in the Port field, as
shown in the following screen.
Ensure the Treadmill Model is set to T2100.
Ensure the COM port number is set to the one physically
connected to in step 2, above, and, if necessary, change to
match.
Click OK to close the System Configuration window and
return to the CASE initial screen.
If needed, the CASE device operating instructions should be
referenced for controlling the treadmill with the CASE
application.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
Assembly and Setup
47