Advertisement
Advertisement
Table of Contents
Summary of Contents for Bearifi EDGE Mesh
- Page 1 User Manual Updated for 2019...
- Page 2 Table of Contents 1. Change your Wi-Fi network name or password 2. TouchLink guest network setup 3. Enable/Disable Smart Connect feature 4. Add a Satellite 5. LED light control 6. Factory Reset...
- Page 3 1. Changing WiFi Name and/or Password Connect your PC or device to the ‘Bearifi’ Wi-Fi signal and log in at the 192.168.10.1 IP address to access the Bearifi Edge administrator area. 3. Change WiFi signal name in 2.4G SSID box, and/or 2.
- Page 4 Instead, when TouchLink is enabled in settings, you or your guest can press the top of the Bearifi Edge Mesh AP unit and the light will flash blue for 60 seconds. During this period, your guest can join the BearifiTouch network without needing a password.
- Page 5 1. Connect your PC or device to Smart Connect is our AI based feature 3. Click WiFi configuration the ‘Bearifi’ Wi-Fi signal that puts your devices on either the 2.4 or 5 GHz bands based on what it and log in at the 192.168.10.1 IP...
- Page 6 4. Adding a Satellite Power on the Satellite within range of your Bearifi Edge Mesh AP. Connect your PC or device to the ‘Bearifi’ Wi-Fi signal and log in at the 192.168.10.1 IP address to access the Bearifi Edge administrator area.
- Page 7 5. LED Control Connect your PC or device to the ‘Bearifi’ Wi-Fi signal and log in at the 192.168.10.1 IP address to access the Bearifi Edge administrator area. 2. Click LED Control 1. Click the Options menu 3. Toggle LED light OFF/ON for Main AP or Satellites...
- Page 8 If your Satellite is no longer recognized by your Bearifi Edge Mesh AP after factory reset (flashes red for more than 180 seconds after power up), you may need to add your Satellite back to your Bearifi Edge Mesh AP device. First try powering the Satellite off and back on, and waiting three minutes. Then refer to...
Need help?
Do you have a question about the EDGE Mesh and is the answer not in the manual?
Questions and answers