Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for PristineHydro WRS-UC3
Summary of Contents for PristineHydro WRS-UC3
- Page 1 INSTALLATION MANUAL...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Purchase Records …………………………….………………………………………………… 3 Introduction …………………………………….…………………………………………………… 4 Component List …………………………….……………………………………………..5 Specifications ………………………………….………………………….……………….….. 6-7 Installation …………………..…………….…………………………………………………………. 8 Maintenance ………………….…………….………………………………………..………….…. 9 Filter Replacement Schedule ……………………….……………………………….. 10 Filter Replacement Procedure …………………………………….….……………... 11 Troubleshooting ……………………………………………………………….……………….. 12 Conditions ……………………………………………………………………….……..…………… 13 Limited Warranty …………………….……..…………………..…..……….…………. 14-15... -
Page 3: Purchase Records
PURCHASE RECORDS Please fill out the following information at the time of installation. SAVE FOR FUTURE REFERENCE MODEL: WRS-UC3 PURCHASE DATE: INSTALL DATE: SOLD BY: INSTALLED BY: SERVICE CENTER PHONE NUMBER:... -
Page 4: Introduction
Please take a few minutes to read through this information. The cartridges in this system must only be replaced with PristineHydro Authorized Replacement Filters and on a regular basis in order to maintain system efficiency and to ensure water production that is 100% free of all undesirable acids and contaminates. -
Page 5: Component List
COMPONENT LIST Your new WATER REVIVAL SYSTEM should include the following items. If any items are missing, please contact your supplier, retailer or any local professional plumbing service. Please take a few moments to check all the following components: • Water Revival System Assembly •... -
Page 6: Specifications
SPECIFICATIONS SYSTEM PERFORMANCE Daily Production Rate 100 GPD Rated Membrane FEED WATER REQUIREMENTS Feed Water Potable, municipal water Feed Pressure 40 to 80 PSI Feed Temperature 45 Deg. F. to 100 Deg. F. Total Dissolved Solids 600 PPM or less Chlorine <1.0 mg/l max Turbidity... - Page 7 INSTALLATION LOCATION: Though most often thought of as an under the kitchen sink counter device, locating the system in a basement or garage may also be convenient, depending on your circumstances. PLACEMENT: The unit should not be further than 10 feet from a drain. Hang the main unit on a wall or cabinet side wall using the holes in the back of the bracket.
-
Page 8: Installation
INSTALLATION START-UP: 1. CLOSE the Tank Valve and OPEN the Angle Stop Valve. If any leaks are noted, CLOSE the Angle Stop Valve and correct before proceeding. 2. OPEN the Faucet water will slowly begin to drip out of the Faucet. This will flush out the system. -
Page 9: Maintenance
MAINTENANCE • Every month or so, it is recommended to flush the High Efficiency Reverse Osmosis Membrane in order to maintain system performance. 1. CLOSE the Tank Valve (perpendicular with GREEN 1/4" tube). 2. OPEN the Faucet to relieve system pressure. 3. -
Page 10: Filter Replacement Schedule
9, 10 Recharging NOTE: Most customers prefer to replace filters pro-actively in order to maintain PristineHydro water quality standards rather than wait for complete filter component degradation. Average Service Life is based on “normal” usage and average feed water quality. Actual filter life will vary with frequency of use, total volume produced, and most importantly, source water quality. -
Page 11: Filter Replacement Procedure
FILTER REPLACEMENT PROCEDURE NOTE: While performing filter changes it is recommended to have a towel handy to dry up any residual water that may leak out from the system. SYSTEM PREPARATION (pre-service check) Turn OFF Storage Tank Valve. Turn OFF Angle Stop Valve. OPEN Faucet to relieve pressure. -
Page 12: Troubleshooting
TROUBLESHOOTING NOTE: Turn OFF the SYSTEM before servicing or inspecting. PROBLEM CAUSE SOLUTIONS Milky colored water - Air in the system * Air in the system is a normal occurrence with initial startup of system. This milky look will disappear during normal use within 1 to 2 weeks. -
Page 13: Conditions
IMPORTANT Please contact your insurance carrier before installing your Water Revival System. PristineHydro WILL NOT be responsible for ANY water damage of any kind under any circumstances. These are our recommendations to avoid water damage. -
Page 14: Limited Warranty
PristineHydro will ship repaired or replacement systems or parts at PristineHydro’s expense. Elements have a one-year pro-rata warranty. If it is established that the element problem is related to material and or workmanship, then the elements will be replaced at no charge in the first month after the date of purchase. - Page 15 , INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. NO AGENT DISTRIBUTOR, RETAILER, OR OTHER PARTY IS AUTHORIZED TO MAKE ANY WARRANTIES ON BEHALF OF PRISTINEHYDRO TO ASSUME FOR PRISTINEHYDRO ANY OTHER LIABILITY IN CONNECTION WITH ANY PRISTINEHYDRO PRODUCT.
Need help?
Do you have a question about the WRS-UC3 and is the answer not in the manual?
Questions and answers