Bar Display Position Adjustment (Op-Disp); Pip Position Adjustment (Pi-Piph, Pipv, Pph5, Ppv5); Text Position Adjustment (Ccd-Cchp) - Sony KP-43T75A Service Manual

KP-43T75A/53SV75A
RM-Y906 RM-Y906
5-5. BAR DISPLAY POSITION ADJUSTMENT
(OP-DISP)
1. Receive the NTSC monoscope signal.
2. Set to service mode.
3. Push " PICTURE +" . (Bar is displayed)
4. Select " OP-DISP " , and adjust so that the bar is as shown in
the figure.
5. Write the data into memory.
MUTING n ENTER
5-6. PIP POSITION ADJUSTMENT
(PI-PIPH, PIPV, PPH5, PPV5)
1. Set the PIP mode.
2. Receive the NTSC monoscope signal on the main/sub
picture.
3. Check the sub picture position.
X1-X2
X1-X2
4. If necessary set to service mode and adjust "PIPH", "PIPV".
5. Write the data into memory.
MUTING n ENTER
X1
6. Receive the PAL-N monoscope signal on the main/sub
picture.
7. Check the sub picture position as specified above.
8. If necessary set to service mode and adjust "PPH5", "PPV5".
9. Write the data into memory.
MUTING n ENTER
X1 X2
X1 = X2
Fig. 5-5
0.25sq
0.25sq
Y1
Y2
X2
Fig. 5-6
5-7. TEXT POSITION ADJUSTMENT
(CCD-CCHP)
1. Receive RF signal with text.
2. Check the text position.
X1 = X2
4. If necessary set to service mode and adjust "CCHP".
5. Write the data into memory.
MUTING n ENTER
X1
– 42 –
X2
Fig. 5-7