Advertisement
Table of Contents
OPT- 7790
TEMPERATURE SENSOR
WATER/AIR/SOLAR
FOR AQUALINK® RS SYSTEMS
FOR YOUR SAFETY:
pool/spa installation. The procedures in this manual must be followed exactly. Improper installation and/or operation can
create dangerous electrical hazards, possibly causing death, serious injury or property damage. Improper installation and/or
operation will void the warranty.
IMPORTANT NOTE: DO NOT overtighten pipe clamp.
The OPT- 7790 Water/Air/Solar temperature sensor can be used to
replace the following Jandy Replacement Kits (R-Kits):
7784 -- Air/Solar Temperature Sensor Kit
7786 -- Air/Water/Solar Temperature Sensor Kit
7790 -- Air/Water/Solar Temperature Sensor Kit
7791 -- Air/Water/Solar Temperature Sensor Kit
P/N OPT-7790
Anything else is simply not
(RS 4, RS 6, RS 8, etc.)
This product must be installed and serviced by a professional service technician, qualified in
Optimum
®
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Optimum OPT-7790
-
Page 1: Temperature Sensor
The OPT- 7790 Water/Air/Solar temperature sensor can be used to replace the following Jandy Replacement Kits (R-Kits): 7784 -- Air/Solar Temperature Sensor Kit 7786 -- Air/Water/Solar Temperature Sensor Kit 7790 -- Air/Water/Solar Temperature Sensor Kit 7791 -- Air/Water/Solar Temperature Sensor Kit P/N OPT-7790... - Page 2 4 Replace the green 10-pin terminal bar on the Power Center Board. 5 Restore power to the system and check for normal system operation. IMPORTANT: Determine the length the sensor wire needs to be. Cut the end of the wire off, DO NOT splice this wire. P/N OPT-7790...
Need help?
Do you have a question about the OPT-7790 and is the answer not in the manual?
Questions and answers