Sayo Innova DBC Series Manual page 4

MANUAL
Remote control strainer
No. Name
01
Drainer component
02
03
04 Screw
05 Strainer bowl
06 Seal
07 Bottom Seal
08 Waste Bowl
Figure (3)The intelligent and ultrasonic sink's strainer parts
3. Installation Method and Steps
Take out the drainage components (01-03) of the strainer, and unscrew the screw (04) in
the strainer bowl (05).
Set the seal (06) around the strainer bowl (05), then put it in the corresponding drainage
opening of the sink.
Set the bottom seal (07) and the waste bowl (08) successively on the back of the sink, and
insert the screw (04) to the interior of the sink and spin to tighten it.
4
Non-remote control strainer
No. Name
09 Button
10 Switch pedestal
11 Spacer
Plastic nut
12
13 Remote control switch
001 Steel wire ball head
002 Drawing pin
003 Adjusting screw
In the case that non-remote control strainer is installed, the installation
is completed. However, if you need to connect a remote control strainer,
please continue the following steps:
The remote control switch (13) going through the installation opening and the spacer (11)
is connected with the switch pedestal (10) and the plastic nut (12), and then screwed to
be fixed.
Note: the spacer should be above the table.
Pull the drawing pin (002) back to a catching groove (as shown in Figure (4)-1), and embed
the steel wire ball head (001) into the steel wire groove (as shown in Figure (4)-2), and
finally pull back drawing pin (002) and fasten the steel wire (as shown in Figure (4)-3).
Press the switch installed down to extend the steel wire from one end.
Install the drainage components in the sink according to installation instructions related.
For specific component names and serial numbers, please refer to Figure (3).
Note: For sealing failures, please screw the adjusting screw (003) lower.
For excessively small drainage, please screw the adjusting screw
(003) higher.
Please keep in mind that do not screw the adjusting screw too high
or low to make it fail to contact the drawbar (03), in which case, the
switch cannot realize the sealing or draining. After adjustment, please
screw the nut on the component tightly to prevent loosening.
4. Intelligent Driver Installation
Put the sink to an opening on the cabinet table.
Plugs of two cables of the sink are plugged into the sockets of the driver respectively and
locked, as shown in Figure (5).
Connect the cables to the driver, as shown in Figure (6).
Note: Please put the intelligent driver into the cabinet, and at least 10cm
away from the bottom of cabinet.
MANUAL
5