Download Print this page
CIC Solar Wild Boar Assembly And Instruction Manual

CIC Solar Wild Boar Assembly And Instruction Manual

Advertisement

Quick Links

GREEN ENERGY
Assembly & Instruction
Manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the Solar Wild Boar and is the answer not in the manual?

Questions and answers

Summary of Contents for CIC Solar Wild Boar

  • Page 1 GREEN ENERGY Assembly & Instruction Manual...
  • Page 2: Mechanical Parts List

    SOLAR WILD BOAR Solar Wild Boar is a basic solar DIY toy, it is ideal for a do-it-yourself science fair, after-school, or summer workshop project with the bonus gift of learning mechanical transmission and electrical motor theory. With only 47 assembly parts, it’s a wonderful instrument for the beginner enthusiast 8 years and up, and a gateway to ignite opportunities in fun learning.
  • Page 3: Plastic Parts

    Plastic Parts Cut the plastic parts when they are required. Do not cut them in advance. Hints Cut off the burrs before assembly. burr burr...
  • Page 4: Mechanical Assembly

    Mechanical Assembly Correct Incorrect P3(Red) Side View Correct P8(Short) Incorrect...
  • Page 5 Correct Incorrect Cut off B4 burrs before assembly. Ensure parts facing the right direction (see below). Correct Incorrect Incorrect Incorrect...
  • Page 6 Use your finger to hold the parts ( as shown below ), it may help you assemble the parts smoothly. Side View Cut off the two burrs before assembly. Use your finger to hold the parts ( as shown above ), it may help Incorrect you assemble the parts smoothly.
  • Page 7 B8x3 Slightly hammer P7 into A5. The open -side - face up ( as per the pic).
  • Page 8 < Note > Step 14~19 Have the parts assemble on the desk/or platfrom, it may help to install smoothly. P9x2 (Long) Very Important ! Press C3 to the bottom. Incorrect C3x2 Correct...
  • Page 9 Very Important ! Please point the feet in the direction illustrated above before inserting B2 part.
  • Page 10 Very Important ! Please point the feet in the direction illustrated before inserting into the shaft. B6x3 Running Incorrect Cut off A7 & A8 burrs before assembly.
  • Page 11: It's Time To Have Some Fun

    It's time to have some FUN ! 1. Take outside under direct sunlight. Best results are obtained when operated on a sunny day. 2. For indoor fun, use a 50 watt halogen light. The product will not run on a cloudy day, shaded locations, indirect sunlight, or under a Fluorescent light.
  • Page 12 Copyright © 2017 CIC. All rights reserved 4350006821...