Dynacord DPM AO-1 Datasheet

Dynacord | DPM AO-1
DPM AO-1
www.dynacord.com
The DPM AO-1 is 2-channel analog audio output
module for the DPM 8016 PROMATRIX CONTROLLER.
The audio signals are connected via screw-in
Euroblock connectors. The output level of both
channels can be switched internally between +6 dBu
and +18 dBu.
Linear, high-precision 24 bit converters are used for
the D/A conversion. The internal signal preparation
uses a 48-bit name length.
Other AO-1 properties:
• 109 dB dynamic range – for the best audio
performance without disruptive incidental noise
• 100 Ω symmetrical output driver – loss-free control of
multiple parallel switched output stages and long
cables
• Output relay – activation delay and rapid separation
for effective suppression of input and output noise.
Automatic control for parallel wiring in redundant
systems
• Automatic configuration – mounting changes/
deviations are detected and displayed in IRIS-Net
• Output transformer – transformers (Lundahl LL1517)
can be retrofitted as an option
Parts included
No. Component
1 DPM AO-1
2 Plug, 3-pin (Phoenix MC 1.5/3-STF-3.81 – no. 18 27
716)
2 Combi-Torx screw M3x10
1 Technical information
Technical specifications
Supply voltage/current
Audio outputs
• Output level (nominal)
• Output level (max. before
clip)
• Output impedance
• Min. load impedance
+3.3 V DC, ± 0.3 V / 6 mA
+5 V DC, ± 0.3 V / 55 mA
+18 V DC, ± 0.5 V / 63 mA
-18 V DC, ± 0.5 V / 30 mA
2 x 3-pin Euroblock connectors,
electronically symmetrical
+6 dBu/1.55 V (jumper closed)
+18 dBu/6.15 V (jumper open)
100 Ω
600 Ω