Ace-Hi AH-100G Quick Start Manual

Things to Know About Gravity Feed Electric Steam Iron:

Power Failure

1)
When you turn the iron on, light comes on the lamp.
if the base is not getting hot,
a) Check thermal fuse
b) Check heating element
c) Check the power source
Water Leak
2)
Gravity feed electric steam iron is the iron that the water goes in and generates the steam
with the temperature inside of the iron. Whenever water goes into the iron, temperature is
dropped each time. When you press thumb switch repeatedly in short period of time, if
the temperature is not enough for the steam to be generated, the iron gives water instead
of steam.
Temp. Setting
Setting 1, 2 Pre-heating. Temperature of the
iron base is very low
Setting 3 This setting is for fine fabric,
and the temperature is still low
and little steam is required.
Setting 4, 5 This setting is for regular and
thick clothes. Temperature is
high. Be cautious while in
operation. Do not leave the iron
unattended.
Application Result When Thumb Switch Is
Pressed
Water flows
Keep pressing thumb switch
makes the water leak so badly.
Just touch the thumb switch only
when steam is needed.
Safe setting for water leak.
Water may leak if you keep
pressing the thumb switch
continuously longer than 40
seconds.