Operating Instructions; Covering The Spa; Uncovering The Spa; Cover Components - Cover Pools Autosave Owner's Manual

Covering the Spa

Remove any objects from the spa.
Keyswitch: Turn the key in the cover direction until the spa
is completely covered. With Auto-shutoff: Turn the key to
"cover" for 1 second, briefly return to "off," then operate
the cover within 4 seconds. After 20 seconds, the switch
will time out.
CoverLink™ control: Enter the four-digit PIN and press
"cover" until the spa is covered.
For Undertrack Systems, release the key or control pad a
few inches before the end of the spa, let the cover coast to a
stop, then press "close" until the front of the cover taps the
end of the spa. This "soft stop" method will improve the life
of the cover and its components rather than overrunning to
the end of the spa under full motor torque and having the
cover hit the end.
For Universal Track Systems, run the cover up to within
two to three inches of the end of the track and stop. Do not
attempt to close the cover completely against the pulley
11pt
castings at the end of the tracks. A convenient way to judge
this is to place a stop mark on the cover, which will align
with a stop mark placed on the tracks at a place where you
12pt
can see it from the control.
Remove the control key from the key switch, and store it in a
secure location to prevent unauthorized operation of the cover.
The CoverLink digital control will deactivate after 20 seconds.
14 pt
©2017 Cover-Pools Incorporated

COVER COMPONENTS

OPERATING INSTRUCTIONS

Place the cover pump on the cover at this time (see
"Placing the Pump on the Cover" on page 6.) Keep the
pump on the cover whenever the spa is covered.

Uncovering the Spa

Remove the pump and any debris from the cover.
Keyswitch: Insert the key and turn it towards "uncover."
Note: If you have an auto-shutoff installed, you must
turn the key twice as described in "Covering the Pool."
CoverLink: Enter the four-digit PIN and press "uncover."
Continue to uncover the spa until the cover is within a few
inches of the end of the spa. Let the cover coast to a stop, then
operate the cover until the spa is completely uncovered.
Do not retract the spa cover too closely to the end of the
tracks. With most undertrack models, the leading edge
should rest half way across the spa end wall. On universal
track models, the leading edge should stop before the
mechanism housing.
WARNING In order to minimize the risk of drowning
which can result in serious injury or loss of life, the control
pad must be mounted permanently on a wall in full view of
the cover. Do not remove the control pad and carry it like
a portable remote. This may be a direct violation of local
codes.
NOTE: Stop the cover briefly before hitting the spa wall or
track ends to increase the life of the cover components.
5
10PT
800119 REL-0005