Table of Contents
Advertisement
3.
The appliance is charged and ready for use.
1.
Turn the Power/Speed Control Knob clockwise to turn the massager on.
2.
Gently apply to specific area on your body.
3.
To increase the Massaging Node speed, Turn the POWER/SPEED Control Knob clockwise.
To decrease Massaging Node speed, turn it counter-clockwise.
4.
To turn off the massager, turn the POWER/SPEED Control Knob counter – clockwise until
its original position.
5.
The massager will stop automatically after working 15minutes for safety reason. To restart
the massager, please turn off the knob, then turn on again later. If you do not want to
continue, please turn off the knob and put it in to the base.
6.
When massaging Node is pressed too hard, it may stop to prevent itself from damage,
please wait for 3 seconds, massager will start working again.
7.
This product is IPX5 level water resistant (except charging base), it can be used under
shower only. Do not use when bathing. Do not place it in water. Do not put it into any tub or
sink.
We suggest to fully charge the massager after first use.
To recharge the battery:
1.
Plug the AC Adaptor into the Charge Base. Plug the AC Adaptor into an electrical outlet.
Then put the massager into the Charge Base and make sure the Charging Connector is
applied to the right place.
2.
The Charging Indicator LED will turn to red to indicate charging. When fully charged, the
Charging Indicator LED will turn into green.
3.
Approximate charging time is 3hours of 2hours of use.
4.
After charging, please remove the plug from the electricity supply.
How to Operate
-2-
Advertisement
Table of Contents
