Summary of Contents for KDS POWER RC-6S
- Page 1 LCD CHARGER & DISCHARGER KDS POWER RC-6S Model： USE MANUAL Please read the manual before using the charger. thoroughly １...
- Page 2 Lithium pile LCD balance charger & discharger KDS POWER RC-6S Manual A.Specifications: Operating voltage range: DC 11.0- 16.0V AC 100- 240, -50/ 60 HZ 12V DC 5A adaptor Max. charge power: 50W Max. discharge power: 5W Charge current range: 0.1-5.0A Discharge current range: 0.1-1.0A...
- Page 3 Main menu for charge or discharge for Pb battery 5)Program Select Save Data Menu for saving data 6)Program Select Load Data Menu for loading data 7)User Set Program-> Menu for user program ⑴Lithium battery charge or discharge 1.) Charge Main menu will be displayed after start machine Program Select LiPo Batt Press Start / Enter button to confirm...
- Page 4 If battery connect is incorrect, it will display: Connection Break If connecting correct, it will display: The top line: R: *Ser S: *Ser ( Note: R: *SER is the number of battery cells which charger inspect automatically, S: *SER is the number of battery series you set up, if those numbers are different, don’t start to charge, and avoid damaging battery) The low line: switch between Cancel(Stop) and Confirm(Enter)
- Page 5 Charge current choice interface before this, default is charge current by hand, i.e. back is Man typeface. Under this charge method, charger will work as per the charge current you set up, that is KDS POWER RC-6S to forcedly use the charge current you set up, which is not recommended, so can be also changed to automatically charge current control.
- Page 6 The display content is the same as the LiPo, the display content after full charge is the same too. It is full charge when display “FULL” *** Press Batt. Type / Stop to stop charge during charging at any moment. ***Pree Start / Enterto to change the current during charging at any moment, remember reconfirming after changing.
- Page 7 time.： Capacity Cut-Off On 5000mAh The limitation of the charger capacity, that is the charging will stop once exceed the capacity of the figure. The limitation can prevent over charging，but you should set a proper value according to actual setting, or maybe the battery won’t be charged fully. For example, to the battery of 5000mAh，it only could be cut off when setting it 6000mAh.
- Page 8 used for new battery or the battery which has stored for a long time,It is recommended to set to： NiMh Cycle DCHG>CHG 3 Discharge, and then charge, do this for 3 times, it will work after the last charge . 2.) Loading the data in the interface of loading data: Program Select...