Checklist - Flyability 2 Original Instructions Manual

C
HECKLIST
Configurable RC and Removable Antennas:
- Check that the two antennas are properly mated to the Configurable RC.
Check that the two antennas are orientated at 90° to each other.
-
- Check that a steady green status LED is shown on the Power Module prior to starting a
mission.
Configurable RC and Range Extender:
- Check that both connectors are correctly mated to the Configurable RC.
- Check that the cables are functional. To do so, set up the Range Extender and ensure that
a connection is established with the aircraft AND that it can be controlled (e.g. turning the
LEDs on, tilting the camera). Then, turn off the RC and swap the cables prior to turning the
RC on again. Check once again that a connection can be established with the aircraft and
that it can be controlled.
Check that all LEDs and the buzzer are functioning correctly and confirm battery level is
-
adequate:
ORIGINAL INSTRUCTIONSORIGINAL INSTRUCTIONS
Strictly confidential
LED State
LED Pattern
Signification
LED steady
LED blinking
LED off
Battery Level
100% - 80%
80% - 60%
60% - 40%
40% - 20%
20% - 15%
15% - 0%
ELIOS
Use
Page 18 of 24