Replacing The Fuse Of The Car Battery Cord; Mounting The Rotary Commander - Sony D-NE321CK Operating Instructions Manual

Replacing the fuse of the
car battery cord
If the CD player does not operate, check the
fuse. If it is blown, replace it as follows:
1
Turn off the CD player and remove
the cigarette lighter plug from the
cigarette lighter socket.
2
Remove the plug end by turning it
counterclockwise.
3
Remove the defective fuse from the
plug.
4
Insert a new fuse into the plug.
5
Replace the plug end by turning it
clockwise.
Fuse
Remove
Plug end
Notes
• Be sure to use a fuse of the same amperage and
length as the one to be replaced. Never use a piece
of wire as a substitute for the fuse.
• If the fuse is blown again after replacing it, contact
your nearest Sony dealer. In such a case, bring the
defective fuse to the dealer with you.
Cigarette lighter plug
Notes on the car connecting pack
• If no sound is heard or the car connecting
pack is ejected, change the direction of
playback on the car cassette deck.
• Never insert the cord end of the car
connecting pack into the cassette insertion
door. Otherwise, the cord may break or the
car cassette deck may be damaged.
• You cannot use the car connecting pack
with some car cassette deck.
• The cord should be placed so that it does
not hinder driving.
• To disconnect the cord from the CD player,
pull it out by grasping the plug. Never pull
the plug out by the cord.
• With some car cassette decks, you may
hear some rattling noise from the car
connecting pack. However, this is not a sign
of malfunction.
Mounting the rotary
commander
If you use the supplied rotary commander,
you can control your CD player as easily as
you would control the headlight or the wiper
switch of your car while driving.
Attach the rotary commander to a flat place
as illustrated below.
Continued 
11