Advertisement
Quick Links
LOOX Mounting / Programming Instructions: Item no. 833.74.708
The following are programming instructions for the Loox RGB
Remote for the 12v Color Changing Control System.
The Wireless Remote, item 833.74.708, works with the 12v
(833.74.802) Mixer Module.
Up to 10 Mixers can be paired to a single Wireless Remote.
4/7/2016
Underground
Advertisement
Summary of Contents for Hafele LOOX 833.74.708
- Page 1 LOOX Mounting / Programming Instructions: Item no. 833.74.708 The following are programming instructions for the Loox RGB Remote for the 12v Color Changing Control System. The Wireless Remote, item 833.74.708, works with the 12v (833.74.802) Mixer Module. ...
- Page 2 LOOX Mounting / Programming Instructions: Item no. 833.74.708 Installing the Battery To install or replace the battery (type CR2032, 3V), remove battery cover. Pay attention to battery orientation (+ faces the battery cover). Slide battery cover into place until the cover snaps closed. ...
- Page 3 LOOX Mounting / Programming Instructions: Item no. 833.74.708 Pairing multiple mixers is handled the same as the first. Syncing multiple mixers is handled by assigning one mixer as the main or master mixer. ...
- Page 4 LOOX Mounting / Programming Instructions: Item no. 833.74.708 Test the pairing by pressing the power button Operating range of the remote to the mixer is 16m or 52 ft. Dimming: Dimming all lights can be achieved by pressing and holding the power button for greater than 3 seconds.
- Page 5 LOOX Mounting / Programming Instructions: Item no. 833.74.708 Color Changing/Cycling: The bottom left 2 buttons are used to set the color cycling to a stepped change and a gradient change mode. Color ChangingTransition Time: The bottom right 2 buttons are used to set the color cycling transition time. 4/7/2016 Underground...
- Page 6 LOOX Mounting / Programming Instructions: Item no. 833.74.708 Scene saving: It is possible to save colors that are able to be recalled with a single button. Once the desired color is achieved, the user may then save the setting to a Scene.