General Specifications - PROFACE AGP3300-U1-D24 Installation Manual

General Specifications

Electrical Specifications
Input Voltage
Rated Voltage
Allowable Voltage
Drop
Power Consumption 26W (max.)
In-Rush Current
Voltage Endurance
Insulation Resistance
Environmental Specifications
Surrounding Air
Temperature
Storage Temperature
Ambient Humidity
Storage Humidity
Dust
Pollution Degree
Structural Specifications
Grounding
*1
Structure
Cooling Method
*1 The front face of the GP unit, installed in a solid panel, has been tested using conditions equivalent to
the standards shown in the specification. Even though the GP unit's level of resistance is equivalent to
these standards, oils that should have no effect on the GP can possibly harm the unit. This can occur in
areas where either vaporized oils are present, or where low viscosity cutting oils are allowed to adhere
to the unit for long periods of time. If the GP's front face protection sheet becomes peeled off, these
conditions can lead to the ingress of oil into the GP and separate protection measures are suggested.
Also, if non-approved oils are present, it may cause deformation or corrosion of the front panel's plastic
cover. Therefore, prior to installing the GP be sure to confirm the type of conditions that will be present
in the GP's operating environment.
If the installation gasket is used for a long period of time, or if the unit and its gasket are removed from
the panel, the original level of the protection cannot be guaranteed. To maintain the original protection
level, be sure to replace the installation gasket regularly.
DC24V
DC19.2 to 28.8V
5ms (max.)
30A (max.)
AC1000V 20mA for 1 minute (between charging and FG terminals)
DC500V 10MΩ (min.) (between charging and FG terminals)
0 to 50°C
-20 to +60°C
10 to 90% RH (Wet bulb temperature: 39°C max. - no
condensation.)
10 to 90% RH (Wet bulb temperature: 39°C max. - no
condensation.)
3
0.1mg/m and below (non-conductive levels)
For use in Pollution Degree 2 environment.
Grounding resistance of 100Ω, 2mm
country's applicable standard.
(Same for FG and SG terminals)
Rating: IP65f NEMA #250 TYPE 1
(Front surface at panel embedding)
Feature size: All-in-one
Installation configuration: Panel embedding
Natural air circulation
4
2
or thicker wire, or your