Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Balboa Instruments EL1001 Mach 3
- Page 1 EL1001 Mach 3 Hot Sheet System Model # E1P-EL1001M3-DCAH Software Version # 28 EPN # 2130 Base PCBA - PN 54389-02 PCB EL1000 – PN 22952 Rev B or C Base Panels ML400 – PN 52684 Template used: 40572-v28_A.pdf 11/09/2006 55069_02-97_A.pdf 11/16/2006...
-
Page 2: Power Requirements
Basic System Features and Functions Power Requirements • 240VAC, 60Hz, 40A, Class A GFCI-protected service (Circuit Breaker rating = 50A max.) • 4 wires (hot, hot, neutral, ground) System Outputs Setup 1 (As Manufactured) • 240V Pump 1, 2-Speed • 240V Circ Pump •... - Page 3 Persistent Memory and Powering Up Any time you change DIP Switches or Software Configuration Settings that message on power up: affect parameters the user can change (any filter settings, set temperature If “ ” appears before (and instead of) “ ”...
- Page 4 Wiring Configuration and DIP Settings Setup 1 (As Manufactured) • 240V Pump 1, 2-Speed • 120V Ozone • ML400 Main Panel • 240V Circ Pump • 12V Spa Light • 240V Blower • 240V 5.5kW Heater FUSE 3A 250V FUSE 10A 250V CLASS G FUSE 30A 12V Light...
- Page 5 DIP Switches and Jumpers Definitions WARNING: • Setting DIP switches incorrectly may cause abnormal system behavior and/or damage to system components. • Refer to Switchbank illustration on Wiring Configuration page for correct settings for this system. • Contact Balboa if you require additional configuration pages added to this hot sheet. DIP Switchbank A Key 1 .
-
Page 6: Configuration Options
Configuration Options FUSE 3A 250V FUSE 10A 250V CLASS G FUSE 30A BLK AC WHT AC P1 LO ALRM J23 J19 FUSE 0.3A 250V 12V-A TORQUE RANGE FOR TB1: 27-30 IN. LBS. J53 J54 J55 RED AC ADCM REMOTE Balboa HTR2 HTR1 EL1000 Mach III... -
Page 7: Expander Options
Expander Options F10A 250V PN 53544 PN 53310 Used for a 1-speed Pump 2 output ONLY. Used for a Blower output ONLY. • Cannot be used with X-B • Cannot be used with X-P P/N 22909 REV B F30A 480V X-03 PN 53426 PN 53681... - Page 8 Ozone Connections Ozone Connection Voltage: Ozone Connection #1 - Using the J9 On-board Connector • The EL1000 Circuit Board to deliver the desired voltage to the on-board connector (J9). Connect the W13 wire to J86 AND the wire from J95 to either White AC (120V) or Red AC (240V) to change the voltage setting if required. •...
-
Page 9: Panel Configurations
Panel Configurations Heat Jets Temp Light ML400 PN 52684 with Overlay PN 11345 • Connects to Main Panel terminal J70 or J71 55069_02-97_A...