Aquatic Life MACRO AQUA FLOW SWING Instruction Manual

PARTS LIST
Item
#660366 #660367
Motorized Motorized
Diffuser Diffuser
1/2" PVC Slip 3/4" PVC Slip
Adapter Adapter
5/8" Hose Barb 3/4" Hose Barb
Adapter Adapter
Tank Mount Tank Mount
Bracket Bracket
PRODUCT SPECIFICATIONS
Power Cord Length: 5 FT
Power Supply: 110V, 60 Hz
Directional Angle: 100°
See The
Flow Swing
in Action!
Scan Code
or
CLICK HERE
to see the
Flow Swing
in Action
FLOW SWING
Item Item
#660368
Motorized
Diffuser
with
Built-In
1" PVC Slip
Item # 660366 Shown
Flow
Swing
Power
Cord
Aquarium
Drip Loop
www.AquaticLife.com
Instruction Guide
OVERVIEW
The Flow Swing is designed to create a dynamic water flow
in any aquarium, helping eliminate "dead spots".
The motor in the Flow Swing continuously moves the
diffuser from side-to-side, changing the direction of the
filtered water.
The speed at which the diffuser moves from left to right is
about 5 seconds, where-as right-to-left is about 10 seconds.
This variance creates wave-type currents which helps
sweep away excess detritus and waste products.
The inlet on the Flow Swing is adjustable by either using the
included PVC slip adapter or the hose barb fitting-making it
easy to connect to the return water line from the aquarium filter.
The Flow Swing is held in place in the aquarium with a
specially designed tank mount. The mount features hinged
suction cups that can accommodate placement on a flat
surface all the way up to a 90° angled surface.
If the return line is fixed, the Flow Swing can also hang
in the aquarium.
NOTE: The hose barb fittings and tank mount bracket
are included with the two smaller models (660366 &
660367). The largest model (660368) is designed to be
connected directly to 1" rigid PVC pipe.
INSTALLATION
1) Determine where you would like to place the Flow Swing
in the aquarium for the maximum benefit of water
movement. Avoid placing the diffuser where it is
obstructed by rock or other objects.
2) With the Flow Swing unplugged, connect either the
PVC FPT adapter or the hose barb adapter to the
motorized diffuser. Hand tighten only.
3) Connect the filtered water return line
to the Flow Swing.
4) Insert the motorized diffuser into the tank mount
with suction cups.
5) Remove any algae or debris from the tank wall where
you plan to secure the Flow Swing. Attach the Flow
Swing to the tank using the four suction cups.
6) Create a drip loop and connect the power cord to
an electric outlet.
MAINTENANCE
Periodically inspect the Flow Swing for signs of debris
accumulation. Wipe clean with a cloth or soft algae pad.
1