Boot The Installed Loadmaster - Kemp LoadMaster Installation Manual

Dell R-Series
Connect the Dell R-Series
5. Select the target disk for installation and press OK.
6. Select delete existing partition(s) and press OK.
7. Select start installation and press OK.
8. Press OK. The installation should complete successfully.
2.2
The server is now ready to be rebooted with the LoadMaster software installed on the local disk.
Within the console, select the Ctrl-Alt-Del option from the Macros drop-down menu.
The server should now begin to boot from the local disk.
Occasionally, call trace code may appear while the LoadMaster is booting
The LoadMaster should obtain an IP address via DHCP, please note this value.
If the LoadMaster does not obtain an IP address via DHCP then the LoadMaster must be manually
configured using the console once the license key has been obtained.
Copyright © 2002 - 2016 KEMP Technologies, Inc. All Rights Reserved.
Figure 2-3: Select the target disk
Figure 2-4: Delete existing partition(s)
PXE and USB booting options are also supported by the LoadMaster

Boot the Installed LoadMaster

up. This can be ignored.
Figure 2-5: Start installation
installation ISO file.
7