Advertisement
Quick Links
966-II Air Ionizer User Guide
Safety Precautions..........................................................................................2
Specifications ................................................................................................3
Installation & Wiring ........................................................................................4
Operation.......................................................................................................5
LED State & Input............................................................................................6
Troubleshooting...............................................................................................7
General Precautions for Use...............................................................................8
・
This Product is not specified as an Explosion-proof Type. Do not use this unit at a location or an atmosphere in which
combustible gas or solvent is handled, or else ignition or explosion may occur.
・
A high voltage is applied to the discharge needle. Do not allow any conductive material, including your finger, any part
of your body, wire or any tool to get close to the needle, or an electrical shock accident or a malfunction of the Unit may
occur.
・
The tip of the discharge needle is sharp, be careful not to touch the discharge needle.
DESCO ASIA
TB-9096
Page 1 of 8
Warning
© 2019 DESCO INDUSTRIES INC
Employee Owned
Advertisement
Summary of Contents for Desco SCS 966-II
-
Page 1: Table Of Contents
Unit may occur. ・ The tip of the discharge needle is sharp, be careful not to touch the discharge needle. DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 1 of 8 Employee Owned... -
Page 2: Safety Precautions
The nozzle can fit the main unit. Appearance: DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 2 of 8 Employee Owned... -
Page 3: Specifications
Always check this manual to ensure that the product wiring is done correctly. Errors in wiring could lead to problems or abnormal operation of the product. DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 3 of 8 Employee Owned... - Page 4 The signal is turned on, lights up when a dirt or wear of Green C.C-NO Output the discharge needle is detected. (NO) Brown HV-OFF Input When the signal is short circuited to 0V, discharge stops. I/O Circuit Diagram: DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 4 of 8 Employee Owned...
-
Page 5: Operation
Working Range" under "4. Specifications" for the working range of air pressure. When you attach the tube to the nozzle, move the tip of the tube closer to the charged object and blow ion air. DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 5 of 8 Employee Owned... -
Page 6: Led State & Input
LOCK direction (clockwise) until the locked knob is securely locked with the main unit. Tightening torque is 8 to 10N・cm. DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 6 of 8... -
Page 7: Troubleshooting
Replace the entire discharge needle unit with a new Wear on discharge needle Lights up. one. Check that the discharge needle is free from Abnormal discharge conductive materials. DESCO ASIA © 2019 DESCO INDUSTRIES INC TB-9096 Page 7 of 8 Employee Owned... -
Page 8: General Precautions For Use
If the product emits any abnormal odors or sounds, smoke, or heat, turn OFF the main power immediately, ・ remove the power cord, and contact Desco Asia. Failure to do so may result in fire or a short circuit. Do not directly touch the discharge needle with your hands.