Advertisement
Quick Links
Advertisement
Summary of Contents for FANTEM Oomi Touch
- Page 1 Oomi Touch (Z-Wave Touch)
-
Page 2: Change History
Change history Revision Date Change Description 11/20/2015 Initial draft. -
Page 3: Table Of Contents
Table and contents Change history ............................2 Introduction ............................. 4 Familiarize yourself with your Touch ....................4 Basic Network Installation Functions ....................4 Reset your Touch ..........................5 Z-Wave Chip ............................. 5 Z-Wave version ..........................5 Z-Wave library type .......................... 5 Z-Wave Device Type ......................... -
Page 4: Introduction
1. Introduction Oomi Touch is a smart mobility device based on the android OS.It is not only a touch device but also a Z- Wave touch sensor, it has built in a Z-Wave module, which let you can easily receive its sensor notifications form anywhere in the world. -
Page 5: Reset Your Touch
1. Set your Z-Wave hub/primary Controller into adding/inclusion mode. 2. Press the “Learn” button on the operation page of your Touch. 3. If the Touch has been successfully added to your Z-Wave network, it will pop up a message “the adding is successful”, if not, repeat the steps above. -
Page 6: Installer Icon Type
Installer Icon Type 0x0C06 (ICON_TYPE_SPECIFIC_SENSOR_NOTIFICATION_ACCESS_CONTROL) User Icon Type 0x0C06 (ICON_TYPE_SPECIFIC_SENSOR_NOTIFICATION_ACCESS_CONTROL) Manufacture ID 0x016A Product Type ID US version: 0x0102 AU version: 0x0002 EU version: 0x0202 Product ID 0x0066 RF Range Up to 100 meters outdoors. Wireless technology Z-Wave 908.42MHz/868.42MHz/921.42MHz. Wi-Fi 2.4GHz 802.11b/g/n. Bluetooth 4.0. NFC. Z-Wave Command Class list Included Non-Secure Included Secure... -
Page 7: Button Functions Of Each Trigger In The Touch Sensor
COMMAND_CLASS_ASSOCIATION V2 Command COMMAND_CLASS_POWERLEVEL V1 Supported COMMAND_CLASS_NOTIFICATION V4 Report COMMAND_CLASS_BASIC Frame COMMAND_CLASS_BATTERY COMMAND_CLASS_CONFIGURATION V1 COMMAND_CLASS_FIRMWARE_UPDATE_MD Button functions of each trigger in the touch sensor page Button Trigger Description Learn Button Click 1. Let your Touch into Learn Mode which can add it into Z-Wave network or remove it from Z-Wave network. - Page 8 The Touch supports 1 association group and can add Max 5 nodes in group 1. Association Nodes Send Mode Send Commands Group Group 1 [1,5] Single Cast Send Notification Report CC/Hail CC when the Sensor is triggered. Association Group Info Command Class Association Group Info Report Command Class Profile: General: NA (Profile MSB=0, Profile LSB=0) Association Group Name Report Command Class...