Advertisement
Advertisement
Table of Contents
Summary of Contents for Condeco 10.1" V2 Room Screen
- Page 1 Condeco 10.1” V2 Room Screen (T201502) Mounting Information...
- Page 2 Contents General instructions ........................... 3 Mounting on Glass ............................7 Screen Commission Pre-requisites ......................8 Contact ................................. 9 Condeco 10.1’’ Room Screen Mounting Instructions Page 2 of 9...
-
Page 3: General Instructions
General instructions The Condeco screen can be mounted to solid or partition walls using the mounting plate supplied and suitable fixings. When deciding where to mount the Condeco room screen please consider the locations of the cable entry points on the back plate. - Page 4 Once desired screen height is finalised, the back needs to be fixed to the wall using the screws supplied or using double sided tape (for mounting on Glass) to secure the back plate in position. Fixing Point Fixing Point Condeco 10.1’’ Room Screen Mounting Instructions Page 4 of 9...
- Page 5 Feed the LAN cable in the cable guide recess that is present on the back plate and the device and also based on where the LAN cable needs to be routed to. Network Cable Input Network Cable Input (Both Sides) Condeco 10.1’’ Room Screen Mounting Instructions Page 5 of 9...
- Page 6 Clip the screen on to the back plate and screw the unit in place using the screws provided. Fixing screws to fix the unit to the back plate. Condeco 10.1’’ Room Screen Mounting Instructions Page 6 of 9...
-
Page 7: Mounting On Glass
Mounting on Glass The following illustration shows a Condeco screen mounted to Glass. When mounting on glass we recommend that the use of the following materials. VHB Tape Screen Back Plate Vinyl To fix the screen to the Glass wall, you will need to use the pre cut strips between the back plate and the Vinyl. -
Page 8: Screen Commission Pre-Requisites
The network point should be tested to ensure routing of http traffic port 80 is available to the server that the Condeco software is to be installed on. If the use of static IP addresses is required these should be pre-allocated and the... -
Page 9: Contact
Contact Europe (Head Office) 8th Floor Exchange Tower 2 Harbour Exchange Square London E14 9GE Tel +44 (0)20 7001 2020 europe@condecosoftware.com Condeco 10.1’’ Room Screen Mounting Instructions Page 9 of 9...
Need help?
Do you have a question about the 10.1" V2 Room Screen and is the answer not in the manual?
Questions and answers