Enabling Ethernet - Sony VAIO Digital Studio PCV-RX270DS, PCV-RX260DS, PCV-RX280DS User Manual

Enabling Ethernet

Your computer comes with a preinstalled Ethernet interface. To enable faster
startup, your computer ships with this function disabled. You may enable
Ethernet connectivity by following the instructions below.
To enable the Ethernet connection
1 Right-click My Computer on the desktop and select Properties.
2 Click the Device Manager tab.
Select "Realtek RTL8139 (A/B/C/8130) PCI Fast Ethernet NIC" under the
3
Network Adapters category.
4 Click Properties.
5 Click Enable Device and then click OK.
Click Close.
6
! Warning: Your computer has a protective sticker
located on the rear panel. Connect only 10Base-T and 100Base-TX cables to the
Ethernet port. Using other cables or a telephone cable may result in an electric
current overload and can cause a malfunction, excessive heat or fire in the port.
For help on connecting to a network, see your network administrator.
Enabling Ethernet
covering the Ethernet port
33