LIFEPLUS Lifeleaf User Manual page 2

o Blood pressure
o Respiration rate
o Oxygen saturation
o Blood glucose

The watch also collects the source signal called PPG (photoplethysmography)

The data collected is stored in an internal memory in the smartwatch

The collected data is displayed at the watch screen

The collected data is also wirelessly sent to the user external receiver via bluetooth.
B. User Manual or Instructions for Use
1. Power button is the smartwatch crown.
2. The smartwatch is switched on by pressing and holding the crown for 3 seconds. The
Lifeplus logo appears on the watch screen upon the user pushing the crown
3. The smartwatch is switched off by pressing and holding the crown until the watch goes off
4. The charger is through a magnetic pogo pin that connects at the bottom of the watch. The
charger connector is a USB connector that can be connected to a USB power adapter or to a
laptop. For a faster charge, use the a power outlet and charging via a laptop can be very
slow.
5. The watch has the battery indicator on the main watch face. A full battery can do
continuous measurements of vital for 3 days.
6. It is recommended however not to let the watch's battery run empty. It is recommended to
put the battery on the charger when not in use
7. The watch is connected to the App via BLE 4.0 using the QR-code that is one of the watch
face. Scan the QR-code of the watch with Smartphone where there App is installed and the
watch and the smartphone where the App is installed with be paired via the BLE stack.