Advertisement
Quick Links
Important Information
This unit must be installed by a qualified competent person in compliance with current requirements for
Electrical Installations (IEE Wiring regulations Seventeenth Edition: BS7671).
! Ensure that all power supplying this equipment is switched OFF before working on or inside the unit.
! Confirm the power is off with an appropriately rated volt-sensing device.
! Make sure all devices, covers and doors are replaced and secured before switching the power supply back on to the unit.
! Remove the gland plates prior to slotting or cutting for cable entries to avoid ingress of swarf & other debris.
! The user guide must be available for future reference after installation and testing.
Failure to follow these instructions could result in serious injury or death
Models Available:
TPNEB Empty Expansion Box
TPNA16W 16 Way Type A Modular Service Box
TPNMM Multi-Function Meter Box
All models can be mounted to the top or the bottom of a TPN distribution board although as standard the TPNMM and the
TPNEB come ready to mount to the underside and the TPNA16W to the top of the TPN distribution board.
Page 1 of 2
TPN 3 Phase
Extension Boxes
You Will Need:
n Pozidrive PZ2
n Long Reach Pozidrive
n Hammer
n Adjustable Screwdriver
n Hole Punch/Jigsaw
EDS1078-001
Advertisement
Summary of Contents for Europa components TPN Series
- Page 1 TPN 3 Phase Extension Boxes Important Information This unit must be installed by a qualified competent person in compliance with current requirements for Electrical Installations (IEE Wiring regulations Seventeenth Edition: BS7671). ! Ensure that all power supplying this equipment is switched OFF before working on or inside the unit. ! Confirm the power is off with an appropriately rated volt-sensing device.
- Page 2 Quality Components at Competitive Prices Fitting Instructions: First mount and screw the TPN distribution board to the wall, leaving enough room below or above to site the enclosure, as per the instructions that come with the TPN three phase board. Remove the inner mounting plate of the extension box and leave to one side.
- Page 3 Technical Data: TPNMM Three Phase Board Meter Instructions: The meter has already been programmed and is ready to use, but should the meter need to be re-programmed in order to add other features then the following process should be followed. Before a setting can be changed the meter has to be entered into programme mode. Display Meaning Display...
- Page 4 Technical Data: TPNMM Set Voltage and Current Transformer Ratios: n3.3 = 3 Wire 3 Phase CodE In.Pr In.Pr In.Pr n3.4 = 3 Wire 4 Phase - Factory setting Up Arrow Up Arrow n3.4 Or 3.3 Via the up arrow. Press return twice. In.Pr In.Pr Set Voltage Ratio...
- Page 5 Technical Data: Wiring Schematic TPNMM !"#$%&'(")*+,)-./00)0$'$,).&1$2) !" &' " ( *+,) 1 & B&('C! /))))))))))))34))35))36) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) )) ))))))))))) ))
Need help?
Do you have a question about the TPN Series and is the answer not in the manual?
Questions and answers