Advertisement
When operating the Mist and Light Control Buttons, it's important not to tilt the diffuser. Tip: Put one hand on top of the diffuser
for stability while pushing the buttons with the other hand.
Mist Control
1. Press the Mist Control Button to start the internal fan and begin
the mist. The Mist Control Indicator Light will illuminate red.
2. Press the Mist Control Button a second time to change the
mist to start and stop at 15 second intervals. The Mist Control
Indicator Light will illuminate green.
3. Press the Mist Control Button for 3 seconds, in either mode, to
turn off the mist.
Color-Changing Light Control
1. Press the Light Control Button once to turn on the automatic
color-changing feature.
2. Press the Light Control Button additional times to select specific
colors. At the end of the sequence, the LED light will turn off.
Note: The machine will turn off and the LED light will show red if
the Water Tank contains insufficient water.
Maintenance
Empty and clean the Ultrasonic Aroma Oil Diffuser as needed
to keep the Water Tank, Sensor Pole and Ceramic Disk clean and
free of buildup. Take care to prevent water from getting into the
internal machine parts.
1. To clean the unit, turn off the mist function, then unplug the
Electrical Cord.
2. Take off the Outer and Inner Covers. Pour out the water, taking
care not to let water flow into the internal parts of the machine
(Figure 4). Important: Do not pour water over the Fan Vent.
3. Use a cotton swab to wipe away any build up from the Sensor
Pole and Ceramic Disk (Figure 4).
Troubleshooting
If the mist function does not work, consult the following chart:
Possible Cause
Power supply not connected
Sensor Pole is covered by buildup
Water level is too low
Water level is above the Max Fill Line
Water is too cold
Covers or Fan Vent are blocked by debris
Operation
Solution
Plug in the Electrical Cord and press the Mist Control Button
Use a cotton swab to clean off the buildup
Refill the Water Tank with tap water
Dump out the excess water
Refill with 70 to 120 degree F water
Remove the Covers and clean with a cotton swab
Important: Keep out of the reach of children and pets.
Phone Orders: 1-800-427-3363 • Customer Service: 1-800-876-5520
e-mail: info@gardeners.com • Web: www.gardeners.com
Figure 3
Mist Control Indicator Light
Mist Control Button
Light Control Button
Figure 4
Clean the Water Tank,
Sensor Pole and Ceramic
Disk with a cotton swab.
Power Indicator Light
Warning: Do not pour water
over the flat Fan Vent. Water
may enter and damage the
internal parts of the machine.
Advertisement
