Subscribe to Our Youtube Channel
Summary of Contents for WorkSmart WS-MH-PALL-012
- Page 1 Hand Pallet Truck with Scale WS-MH-PALL-012 Operating Manual Original Instruction...
- Page 2 Please read this instruction manual with great care before you use it. The manual can offer direct help. Note: The WorkSmart WS-MH-PALL-012 hand pallet truck with scale is only used to weigh pallet cargo at your facility. There are lots of advantages of the WorkSmart WS-MH-PALL-012 hand pallet truck with scale.
- Page 3 2.1.3 Turn the pin roll (2), and make sure that the big hole of pin roll is in the vertical position. Put the chain (5) of hand grip through the middle hole of pin roll 2. See fig 2. 2.1.4 Take screw nut which is the end of chain (5) and hitch the groove of lever board (6).
- Page 4 Setting the instrument stand and instruments 2.2.1 See Fig 6. Steelyard stand should located as in the drawing showing how to align the fixed holes. Fig 6 2.2.2 Use three screws (11) to fix the steelyard stand as shown in Fig 6. Connection 2.3.1 Connection wires as shown in Fig 7 Display iPstTWOePt...
- Page 5 3 Operation 3.1 On/Off key Hold the key 2 seconds. All display segments will light. The terminal will show software part number [178037] [L 1.00]. Then the terminal will show the normal weight. In normal display state, Hold this key 2 seconds, the terminal will show [ -OFF- ], then power off.
- Page 6 Maintenance Only the manufacturer or authorized persons may operate or perform maintenance operations. Only use approved spare parts. The routine check is carried out everyday and any abnormal phenomenon should be dealt with immediately. Please do not use a broken truck to prolong operational life span or use the truck without clear marking and warnings.
- Page 7 8.10 When not using the hand pallet truck with scale, make sure that the truck forks are in the lowest position and the power should be off. 8.11 Do not load people and do not stand on the truck forks. Never put any part of your body below the cargo.
Need help?
Do you have a question about the WS-MH-PALL-012 and is the answer not in the manual?
Questions and answers