Connecting To An Antenna Or Cable; Other Connections; Remote Control - LG 42LF5600 Owner's Manual

Connecting to an Antenna or
Cable
Connect an antenna, cable, or cable box to watch
TV while referring to the following. The illustrations
may differ from the actual items and an RF cable is
optional.
CAUTION
• Make sure not to bend the copper wire of the RF
cable.
Copper wire
• Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
NOTE
• Use a signal splitter to use 2 TVs or more.
• DTV Audio Supported Codec: MPEG, Dolby
Digital.

Other Connections

Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable.

Remote Control

(Image shown may differ from your TV.)
The descriptions in this manual are based on
the buttons on the remote control. Please read
this manual carefully and use the TV correctly. To
install batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
to the label inside the compartment, and close
the battery cover. Failure to match the correct
polarities of the battery may cause the battery
to burst or leak, resulting in fire, personal injury,
or ambient pollution. To remove the batteries,
perform the installation actions in reverse. This
remote uses infrared light. When in use, it should
be pointed in the direction of the TV's remote
sensor.
12
• Do not mix old and new batteries, as this may
damage the remote control.
A
(POWER) Turns the TV on or off.
Returns to the last TV channel.
B
Number button Enters numbers.
and ends
(DASH) Inserts a dash between numbers such as 2-1
and 2-2.
selected (pressing repeatedly).
CAUTION
FLASHBK
AUDIO
Activates or deactivates the subtitles.
SAP/
Selects an AV mode.
Resizes an image.
Changes the input source.
Turns the TV on if it is off.
Accesses the saved channel list.
Alternates between the two last channels
Adjusts the volume level.
Accesses your favorite channel list.
Digital signal: Changes the audio language.
Analog signal: Changes the MTS sound.
Mutes all sounds.
Scrolls through the saved channels.
Moves to the previous or next screen.
A
B