Advertisement
Charge times are approximate and will vary depending on specifc device and sun exposure.
* Charging standards vary from device to device. Please consult your device manufacturer for specific charging guidelines and requirements. Please be sure your device powers through a USB
connection.
** Most laptop computers require more power to charge than a portable solar charger can produce on a consistent basis. We recommend the purchase of an auxillary batter pack to store
the solar charger's energy and deliver the specific power required for your device.
14598
7 AMP SOLAR CHARGE CONTROLLER
Protects your 12V lead acid batteries from
overcharge. It is to be used with any P3Solar
charger over 12W and can handle up to
100 Watts of power. With the attached
SAE trailer plug the 7 Amp Solar Charge
Controller can connect directly to the solar
charger and the remaining SAE trailer plug
can connect to any other accessory cable.
28000RC
FCLA 2.5mm BARREL JACK
A 6 inch, 18 AWG zip cord cable. It has
a 2.5mmID barrel jack on one end and
a 12V FCLA receptacle on the other.
This cable can be used to connect to
various electronic devices.
SUNLINQ SOLAR CHARGING CHART
SOLAR CHARGER ACCESSORIES (SOLD SEPARATELY)
22700-1RC
SAE to RING TERMINALS
An 18 inch, 18 AWG zip cord cable. It
has a standard SAE two prong connector
on one end and a set of standard ring
terminals on the other end. The SAE plug
connects directly to the 7 amp charge
controller and the ring terminals connect
to a 12V car battery.
28001RC
SAE to 2.1mm BARREL PLUG
A 4 inch, 18 AWG zip cord cable. It has a
standard SAE two prong connector on one
end and a 2.1mmID x 5.5mmOD barrel plug
on the other end. The SAE plug connects
directly to the solar charger and the barrel
plug connects to various electronic devices
and battery packs including the Tekkeon
myPower All portable batteries (models
MP3450 and MP3700).
22700-2RC - Incl. with Sunlinqs 3, 4 & 5
SAE to FCLA
An 18 inch, 18 AWG zip cord cable. It
has a standard SAE two prong connector
on one end a 12V FCLA receptacle on
the other. The SAE plug connects directly
to the solar charger and the FCLA can be
connected to various electronic devices.
28002RC
2.1mm BARREL PLUG to 2.5mm JACK
A 4 inch, 18 AWG zip cord cable. It has
a 2.5mmID x 5.5mmOD barrel jack on
one end and a 2.1mmID x 5.5mmOD
barrel plug on the other end. This cable
can be used to connect to various
electronic devices.
22700-3RC
SAE to 2.5mm BARREL PLUG
A 4 inch, 18 AWG zip cord cable. It has
a standard SAE two prong connector
on one end and a 2.5mmID x 5.5mmOD
barrel plug on the other end. The SAE plug
connects directly to the solar charger
and the barrel plug connects to various
electronic devices and battery packs.
28003RC
Y-CABLE
The 18 AWG SAE Y-Cable has two 3'
ends that branch from a 1' SAE cable.
Use the SAE Y-Cable to connect two
solar chargers together in parallel if
you need more power. This effectively
doubles the power but the voltage
remains the same.
22700-4RC
SAE to MCLA
An 18 inch 18 AWG zip cord cable. It
has a standard SAE two prong connector
on one end a 12V MCLA plug on the
other. The SAE plug connects directly to
the solar charger and the FCLA can be
connected to various electronic devices.
28007RC
SAE 8 ft EXTENSION
An 8 foot, 18 AWG, jacketed cable with
a two-prong SAE trailer plug on each
end. This cable connects to any of the
accessories with a SAE connection and
plugs directly into the solar charger.
Advertisement
