Summary of Contents for Micro Technologies 406-2
- Page 1 Micro Technologies (NZ) Limited – 406-2 User Manual v1.0.1 MICRO TECHNOLOGIES (NZ) LIMITED 406-2 Beacon Decoder User Manual v1.01 Page 1 of 5...
-
Page 2: Operating Instructions
The 406-2 beacon decoder is small enough to keep with your beacon (able to fit on a keyring), and extremely simple to use and understand with single button operation. No configuration is required and decodes all legitimate 406 beacon transmissions for all 406 beacon types (EPIRB, PLB and ELT). -
Page 3: Technical Information
The 406-2 decoder scans all used 406 beacon frequencies between 406.020MHz and 406.045MHz. Signal Strength Indicator If there is a desire to use the 406-2 decoder as a tool to determine power transmitted from the beacon the following should be considered: When the 406-2 decodes a message, the serial number and hex 15 code is displayed. - Page 4 Micro Technologies (NZ) Limited – 406-2 User Manual v1.0.1 Low Battery Check The 406-2 battery is checked during the self test sequence (immediately after turned on). The coin cell needs replacing when: No indicators light when the button is pressed or when •...
-
Page 5: Specifications
Micro Technologies (NZ) Limited – 406-2 User Manual v1.0.1 406-2 Customisation The 406-2 beacon tester has been developed by Micro Technologies (NZ) Limited, and therefore if a specific requirement exists, customisation of Micro Technologies products may be possible (at additional cost).
Need help?
Do you have a question about the 406-2 and is the answer not in the manual?
Questions and answers