Table of Contents
Advertisement
Quick Links
Important Safety Demands For Sanders
Covington Engineering designs machines with safety in mind. Please read our Safety Demands Sheet carefully
and follow for your safety and the safety of others.
ELECTRICAL
Have your licensed electrician electrically ground your machines and equipment (against electrical shock) by
complying with federal, state, and local laws. Locate electrical and in-line switch or switches so operator can
immediately shut them off in an emergency.
DO NOT allow more than one person to operate a machine, unless you have a switch for each person, which is
wired so that any one of the switches will stop the machine in an emergency.
Keep children, visitors, and pets away from electrical devices and machinery.
DO NOT work in wet environments where electricity is present.
DO NOT plug into electricity until the motor switch is off and the proper voltage is supplied.
DO NOT leave motors running when not in use.
DO NOT wear jewelry or rings around electricity.
Keep all electrical cords away from moisture, rain, and moving parts.
Periodically check all cords for worn or frayed spots and replace or repair to code if needed.
Thermally protected motors will stop if overloaded. When they cool, they will start automatically without warning.
If the motor stops, shut the switch off for your protection.
1
Owner's Manual For
Vertical Sanders
464WBS - 466WBS - 760WBS - 761WBS - 764WBS
(Also applies to 220V, 50Hz International Models)
Packet Contents:
• Safety Demands
• Instructions
• Schematic
715 West Colton Avenue
Redlands, CA 92374
Toll Free: (877) 793-6636
Phone: (909) 793-6636
admin@covington-engineering.com
www.covington-engineering.com
2019.01
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for covington 464WBS
Summary of Contents for covington 464WBS
- Page 1 • Instructions • Schematic Important Safety Demands For Sanders Covington Engineering designs machines with safety in mind. Please read our Safety Demands Sheet carefully and follow for your safety and the safety of others. ELECTRICAL Have your licensed electrician electrically ground your machines and equipment (against electrical shock) by complying with federal, state, and local laws.
- Page 2 Specific pinch points on Covington’s vertical sanders also include the area behind the belt, between the drums, as well as in front of the belt between the tool rest and the belt. Keep your fingers away from these areas and do not wear loose clothes or hanging/dangling items near this machine as they can get caught and cause severe injury.
- Page 3 (one of each grit + an extra 100g) with your sander in order to experiment with all of the grits. All Covington sanders come equipped with a backing plate and a brass valve for water hook- up.
- Page 4 back onto the valve using a 1/2” wrench. The insert allows the ferrule to collapse onto the insert which creates a seal and prevents leaking. If you purchased a plumbing kit, the tubing and insert are both included. A small amount of water is sufficient to keep the belt wet.
- Page 5 take off the loose belt and place the replacement belt around the two drums. It is best if you can slide the belt on as far as possible before tightening the tri-knob. Once the belt is in place, tighten the tri-knob by turning it towards the front of the machine (clockwise).
- Page 6 An excellent general-purpose polishing compound is optical grade cerium oxide on a felt belt. Covington’s felt belts are made out of wool and will shrink if not used and stored properly. Should you decide to polish with a felt belt, it is very important to make it the last process of the day on your machine.
- Page 7 2019.01...
Need help?
Do you have a question about the 464WBS and is the answer not in the manual?
Questions and answers