CANARMNA LBL167A14WACBK Manual

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
!
SAVE THESE INSTRUCTIONS
SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.
4. NOT FOR USE IN LUMINAIRES CONTROLLED BY A DIMMER.
5. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH
A CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION:
Arm
White Wire
Electrical
Black Wire
Box
Ground
Wire
Back Plate Gasket
Back Plate Gasket
Back Plate
Screws
Set Screws
Weather Resistant Caulking
(not included)
Weather Resistant Caulking
(not included)
LED OUTDOOR
LIGHTING
QUESTIONS OR CONCERNS CONTACT AT:
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
1.
Shade
2.
gasket in place. Seal other end of arm into back plate with gasket in place.
Back Plate
3.
the ground wire (bare copper or green) or ground screw in the electrical
outlet box. Connect black wire from fixture to black wire in outlet box and
connect the white wire from fixture to white wire in outlet box.
4.
using screws provided.
5.
6.
fixture and the wall surface with weather resistant caulking. The bottom
should be left un-caulked to prevent moisture build-up.
Tel: (613) 342-5424, Fax: (800) 263-4598
WARNING: SUITABLE FOR WET LOCATIONS WHEN
THREADS ARE SEALED WITH TEFLON
!
TAPE OR PIPE SEAL.
Run black, white and green wires from fixture through arm.
Screw the arm onto the shade. Put the back plate and back plate
Connect the ground wires (bare copper or green) from your fixture to
Put back plate gasket in place and attach backplate to junction box
Align fixture and secure by tightening set screws on backplate.
After Installation, seal around the top and side perimeter between the
TOOLS AND MATERIALS REQUIRED:
Pliers
Wire Cutters
Phillips
Blade
Screwdriver
Screwdriver
LBL167A14WACBK
01/19
Wiring supplies
as required by
local electrical
code