Setting Up Your Serial Port - VETEC P1001 Series Manual

You can choose from :-
Baud rates in the range 300 to 115200
Data formats of 8n1,7n1,7e1 or 7o1
Protocol C1 for continuous output (Link "Enable" to "Common" on output connector)
Protocol P1 for polled output
Protocol P2 for Modbus ASCII mode
This feature is available in Easy and Advanced Modes
Set1
Digit
1
Press briefly together
Set1
Digit
2
Set1
Digit
3
Setting up your Serial output port
Set2 Output Alarms
OK
Max/Min Reset
Set2 Output Alarms
OK
Max/Min Reset
baud 9600
Choose a baud rate to suit the receiver.
Data format 8 data bits, no parity, 1 stop
dF. 8n1
Protocol. C1 = continuous, P1 = polled
Prot.C1
The display's address, from 00 to FF. Choose
Addr.00
00 if you do not need addressing.
t.reP.05
Time to reply following a request, in mS
t.chr.00
Time in mS between each character.
Set2 Output
Alarms
OK
Max/Min Reset
Press to accept
Lockout Switch must be OFF
Display shows each of the parameters
and you can edit or move on to the next
one with the OK button.
You can edit the settings with the DIGIT,
UP and DOWN buttons. OK to accept.
The default parameters are:-
OFF
Circuit board ON
Done!
7