Denon Professional DN-500CB Manual

Serial command protocol
Hide thumbs Also See for DN-500CB:

Advertisement

Quick Links

Serial Command Protocol Guide
English

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DN-500CB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Denon Professional DN-500CB

  • Page 1 Serial Command Protocol Guide English...
  • Page 2: Table Of Contents

    Table of Contents Introduction ..........................3 Support ..........................3 General Overview ........................3 Connecting the Host to DN-500CB ..................3 Communication Protocol ......................4 Types of Serial Communication .................... 4 Structure of the Codes ......................5 Rules on Transmitting Command Codes ................5 Control Command Codes ......................
  • Page 3: Introduction

    For serial remote control, you must first connect the host to your DN-500CB. Use an RS-232C Straight Cable (9-Pin D-Sub Male) to connect the RS-232C input on the rear panel of your DN-500CB to the corresponding input on the host. Make sure that the host is running appropriate software for serial communication.
  • Page 4: Communication Protocol

    Communication Protocol Types of Serial Communication Three types of serial communication can be transmitted between the host and DN-500CB: 1. Control commands sent to DN-500CB from the host DN-500CB Host You can use control commands to make DN- Control 500CB perform a desired function (such as playing Command or skipping a track).
  • Page 5: Structure Of The Codes

    The required start character/ID and end character are the same in all codes, whereas the command portion varies with each code. For example, the full control command code that the host would use to power on DN-500CB would be @0PW00\r:...
  • Page 6: Control Command Codes

    Control Command Codes Control Commands (Host → DN-500CB) CATEGORY CONTENTS CODE DESCRIPTION Power On @0PW00 Powers on DN-500CB Power Power Off @0PW01 Powers off DN-500CB Disc Drive Eject @0PCDTRYOP Ejects the disc from the CD slot Play @02353 Plays the current track...
  • Page 7: Status Request Command Codes/Status Information Codes

    Status Request Command Codes/Status Information Codes Status Request Status Information Commands (DN-500CB → Host) (Host → DN-500CB) DESCRIPTION REQUEST CODE ANSWER CODE The power is on Power Status @0?PW No answer The power is off No Disc @0CDNC There is no disc in the CD slot...
  • Page 8: Appendix

    5 V / 500 mA power supply can be used for RTS. Trademarks & Licenses Denon is a trademark of D&M Holdings Inc., registered in the U.S. and other countries. Denon Professional products are produced by inMusic Brands, Inc., Cumberland, RI 02864, USA.
  • Page 9 denonpro.com Manual Version 1.4...

Table of Contents