Download Print this page

Advertisement

Quick Links

Safety Precautions and Warnings
This radio is not a toy and should not be operated by anybody under 14 years of age. Adult
supervision is required.
Always ensure radio is on before turning on car or injury or damage can occur.
Always perform system check to ensure throttle and steering is working correct before
operating.
Do not mix old and new batteries. It is recommended to use only alkaline batteries.
Do not operate radio in rain or wet environment.
Ensure Failsafe function is set before operating vehicle.
Do no hold transmitter by antenna while operating, this will decrease performance.

Transmitter Operation

Caution:
Never hold the trigger when turning on transmitter. Ensure you understand all features
of transmitter before using. Do not drop transmitter or damage can occur.

Transmitter Features

1.
Steering Wheel: Controls direction of model (left/right).
2.
Throttle Trigger: Controls direction of model (forward/reverse).
3.
Power Switch: Turns transmitter on and off.
4.
Power LED: Indicates if transmitter is on or off.
5.
Power Check
6.
Steering Trim: Adjusts the centering of the models front tires.
7.
Steering Dual Rate: Adjusts the amount the models front tires turn front right to left.
8.
Throttle Trim: Adjusts the motors speed when trigger is at neutral position.
9.
Steering Reverse: Switch that will reverse the direction of steering servo.
10. Throttle Reverse: Switch that will reverse the direction of the motor when trigger is moved.
11. Bind Button: Used to bind transmitter to receiver.
12. Battery Door: Remove door to install 4x AA batteries.
10
11
9
4
5
8
3
1
6
7
2
12
1

Advertisement

loading

Summary of Contents for FLYSCY FS-GT2E

  • Page 1: Transmitter Operation

    Safety Precautions and Warnings  This radio is not a toy and should not be operated by anybody under 14 years of age. Adult supervision is required.  Always ensure radio is on before turning on car or injury or damage can occur. ...
  • Page 2 Binding Transmitter to Model Failsafe Setting Plug in bind plug to Bind Port on receiver. The failsafe will help prevent an out of control situation if the transmitter signal is lost. How to Set the Failsafe: Turn on cars on/off switch (located on bottom of the car) and LED on receiver will start to flash rapidly.