SciCan Aquastat Quick Reference Manual

AQUASTAT
Please read the Operator Manual and this Quick Reference Guide before using your Aquastat Water Distiller.
Reservoir
Valve
Gasket Water Bottle

1. Start-Up

Place your Aquastat on a dry, level surface in a well-ventilated area. Plug the cord into a properly grounded
outlet.

2. Cleaning Your Aquastat

1. To clean the water bottle, tighten the reservoirvalve and fill the
water bottle 3/4 full with water.
2. Add 1-2 drops of dishwashing detergent and vigorously shake the
water bottle.
3. Empty the bottle and thoroughly rinse to remove detergent.

3. Sanitizing Your Aquastat

1. Add 5 ounces (150Ml) of 3% hydrogen peroxide solution (H
2. Fill the bottle with hot (160
3. Cap the water bottle and shake vigorously.
4. Let stand for twenty minutes then drain thoroughly.
5.Rinse with room temperature distilled water, then drain. The
water bottle may be used immediately or allowed to air dry.

4. Fill the boiling chamber.

1.Remove the boiling chamber from the chassis and remove
the boiling chamber cap. Note the four tabs at the base of the boiling chamber's fill opening.
2.Fill the boiling chamber with cold tap water up to the bottom of the four tabs.
Boiling
Chamber

Quick Reference Guide

Boiling Chamber Cap
Cap
Baffle
Baffle Gasket
Boiling Chamber
° °C
F/71 ) distilled or tap water.
Chassis
O-Ring
Baffle Nut
Distiller Chassis
O ) to the water bottle.
2 2
Start Button
Cooling Vents
Cord
Dispensing
Valve
Boiling Chamber Cap
Baffle
Tabs