Page 1
6X6 AUDIO DISTRIBUTION K-9604 POWER 9604 6x6 audio matrix with 6 bridgeable zones to accomodate 1 or 2 speakers per zone Integrated the device via the network. OWNERS MANUAL...
Page 3
The K-9604 is a functional, easy-to-install, highly compatible, expandable, and user-friendly audio distribution system. It provides up to 25W @ 8 Ohm Power by Class D amplifier to up to 18 zones which at can be controlled by packaged keypads (included with K-9604 unit), RS232,IR or network. Overall the distribution systems easy-to- install, so every audiophile can enjoy the powerful audio wherever they are.
Page 5
K-9604 POWER K-9604 14 15 Integrated network...
Page 9
The K-9604 can work with speakers that are 4-8 Ohm. There are 9 two modes that can be set for different setups: Stereo or Bridge. An 8 Ohm speaker can only be used when in Bridge mode. To choose between...
Page 10
The K-9604 comes with 6 POE enabled keypads. This allows for source control from each specific zone as well as IR routing to the appropriate source devices once selected. The K-9604 also comes with a hub that allows for all 6-keypads to be connected to the amp via Cat5e/6.
Page 13
IR + IR - The K-9604 can allow 6 sources to be distributed to up to 18 zones on 3 different units using the provided ribbon cable to connect between units. To do this first each unit needs to be addressed according using the MASTER/SLAVE switch.
Page 14
INTEGRATED NETWORK Set the switch to Ethernet. Connect the Cat5 cable to Ethernet port and LAN port of the Router.
Page 15
Router to find the IP address of K-9604 (shown as below) 9604 Then enter the IP address of K-9604 to the IE browser (shown as below), ensure the Serial Configure is 9600. After finishing this step, K-9604 could be controlled through the local Network.
Page 16
Download free software Serial&TCP/UDP Tool from the internet to control the device. Operation diagram as below:...
Page 17
K-9604 AT COMMAND CODE 'CR':Carriage Return (0x0D) : Zone1 of Main unit 1 No case capitalization/ lowercase : Zone2 of Main unit 1 Control order structure <xxPPuu'CR' : Zone3 of Main unit 1 Reply control order frame >xxPPuu'CR' : Zone1 of Main unit 2...
Page 18
K-9604 AT COMMAND CODE PP: Stands for control action code. Key in <115200'CR' change RS232 speed rate to 115200 PA: PA control Key in <230400'CR' change RS232 PR: Power control speed rate to 230400 MU: Mute control When unplugging and re-plugging the...
Page 19
K-9604 AT COMMAND CODE Reply command: >xxPPuu'CR' On the keypad when the keypad is turned *******needs to be 8 ASCII codes. Key in 1<********'CR' change Source 1 Key in <9600'CR' change RS232 speed rate Name display to 9600 Key in 2<********'CR' change Source 2 Key in <19200'CR' change RS232 speed...