NETGEAR Orbi Pro Ceiling Satellite User Manual page 15

To sync your satellite using the Sync button on both the Orbi Pro router and the
satellite:
1. For the sync process, place your Orbi Pro satellite in an area near your Orbi Pro
router.
For example, place your satellite in the same room as your router, but not too close
to the router. We suggest that you keep a distance of 20–25 feet (about 6–7 meters)
between the satellite and the router.
2. Connect your satellite to a power source.
Either connect the power adapter to the satellite and to a power source, or connect
PoE+ LAN port 1 on the satellite to an Ethernet cable and to a Power over Ethernet
Plus (PoE+) switch that can provide 802.3at (PoE+) power.
The Power LED on the top panel of the satellite lights solid green.
Note: If the Power LED does not light, check the power source or the PoE+ switch.
If the Power LED lights red, the power is not at the required 802.3at (PoE+) level.
Make sure that you use an 802.3at (PoE+) switch and not an 802.af (PoE) switch.
3. Wait for the LED bar (next to the Power LED) to light solid white.
The following is the LED behavior during booting:
• Pulsing white. The satellite is booting.
• Solid white. The satellite finished booting and is ready to sync with your router.
4. Press the Sync button on the back of your satellite, and within two minutes, press
the Sync button on the back of your router.
5. Wait for the satellite to sync with the router.
The LED bar on the satellite lights pulsing white while it attempts to sync with your
router. It might take about six minutes for your satellite to sync.
After the LED bar lights white, it lights one of the following colors for about three
minutes and then turns off.
Overview
Orbi Pro Ceiling Satellite
15 User Manual