Feature Guide; Control Panel; On/Off Button - ACCO Brands Pinnacle 27 Installation & Operation Manual

5. Feature Guide

Figure 1
Figure 2
A. MAIN POWER SWITCH: Located at the back of the
machine, applies power to the laminator. The 'ON'
position is indicated by the 'I' symbol. The 'OFF'
position marked 'O' symbol (figure 2).
Figure 3
B. CONTROL PANEL:
a. FOOTAGE COUNTER – Tracks the number of feet
used since last reset. To reset the footage counter
press the RESET button.
b. ON/OFF BUTTON –
and wake the machine up form standby
Turns the machine ON/OFF
mode.
i. READY – Machine is ready to use when
machine beeps and
ii. WARM-UP – Machine is warming up when
the LED is AMBER and blinking.
c. FILM SELECTION –
selection button to toggle between NAP I and
NAP II films.
d. SPEED CONTROL – Controls the speed of the
laminator when the run button is pushed.
i. MANUAL SETTINGS 1 THRU 10 – Operator
can manually select the speed 1 –
pressing the up or down arrows.
will increase as you adjust from 1 to 10.
e. RUN – Push the RUN button to run the
laminator in the forward direction.
f. SLOW REVERSE – Press and Hold to run the
machine slowly in Reverse.
will allow the machine to run even when Heat
Shield is open.
g. STOP – Used to stop the laminator.
Figure 4
C. HEAT SHIELD: (figure 4) Prevents inadvertent
contact with the heat rollers. The HEAT SHIELD
must be lowered for the RUN operation to work.
D. FEED TABLE: (figure 4) The Feed Table is used to
position items for lamination. Feed table must be
installed and latched for laminator to operate.
Figure 5
E. FEED TABLE LATCHES: (figure 5) Used to unlock and
lock the FEED TABLE.
F. FEED TABLE GUIDE: (figure 5) Aligns items as they
are being fed into the laminator. Especially helpful
on longer items to reduce skew. The guide can be
moved by loosening the knob and sliding the guide
the LED turns GREEN.
(NAP I or II) – Press the film
10 by
The speed
Using SLOW Speed