Roland Dr. Sample SP-303 Service Notes page 19

Mar.2001
2. RIBON CABLE 14P (P/
No.02671189) shaping method
Bend the SW board (P/No. 71785978) and RIBBON CABLE 14P (P/
No.02671189) vertically, then bend and make a fold line at about 3 cm position
from the main board of the RIBBON CABLE 14P (P/No.02671189)
fig.ribon21
1.
Bend the ribbon cable vertically.
2.
Make a fold line at about 3 cm position from the main board.
Insert the fold line of RIBBON CABLE 14P under the RIBBON CABLE 13P.
fig.ribon22
1.
Insert to the direction of the arrow.
3. RIBON CABLE 13P (P/
No.02671178), RIBON CABLE
11P (P/No.02671167) shaping
method
* Same shaping method can be used for these 2 ribbon cables.
Bend the SW board (P/No.71785978), RIBON CABLE 13P (P/No.02671178)
and RIBBON CABLE 11P (P/No. 02671167) vertically, and bend them
vertically to a position at about 1 cm from the main board (P/No.71785967) of
the RIBBON CABLE 13P (P/No.02671178) and RIBBON CABLE 11P (P/
No.02671167).
fig.ribon31
1.
Bend vertically.
SP-303
19