Do you have a question about the USB-Mini Series and is the answer not in the manual?
Questions and answers
Summary of Contents for CTI USB-Mini Series
Page 1
Optional Accessories (not contained in the shipment) Steckergehäuse mit Zugentlastung für RS-485- Schraubklemme a case with pulling relief for the RS-485 locking ring Anschlusskabel zur Verbindung mit RJ-45 Buchsen a connection cord with RJ-45 plugs office@cti-lean.com www.cti-lean.com made in Germany www.cti-shop.com...
Page 2
USB-Mini Handbuch Konverterfamilie Anschluss an den USB-Port Connection to the USB-interface Das Gerät wird mit dem The device is connected with the beiliegenden USB- enclosed USB-connection cord to a Verbindungskabel an einen USB- USB port of your PC. After the Port Ihres PC angeschlossen.
Page 3
USB-Mini Handbuch Konverterfamilie Konfiguration/Configuration Rote/red Jumper : Abschlusswiderstand/ Termination resistors Jumper Einstellungen/ jumper settings Blauer/blue Jumper: Echo ein/aus Echo on/off Blauer Jumper (Echo ein/aus) Blue jumper (Echo on/off) Ist der Jumper gesteckt, wird ein An Echo is created upon plugging Echo erzeugt.
Page 4
USB-Mini Handbuch Konverterfamilie Technische Daten Technical data Gemeinsame Eigenschaften Common characteristics RS-485 2-Draht bis 32 Bus- RS-485 2-wire up to 32 Bus- Teilnehmer participants RS-485 maximale Datenrate: 3 RS-485 max. data rate: 3Mbit/s Mbit/s (stückgeprüft) RS-485 maximale Leitungslänge RS-485 max. cable length 1200m 1200 m (bei 9600 MBit/s) (at 9600 bit/s) RS-485 Anschluss als...
Page 5
Öffnen des Gehäuses beim USB-Mini Opening of the casing for the USB-Mini Hebeln Sie, wie in der Carefully lever up the Abbildung zu sehen, device at both grooves das Gerät mit einem using a small screw kleinen driver. Remove the top Schraubendreher an cover carefully.
Page 6
USB-Mini Handbuch Konverterfamilie Konfiguration /Configuration USB-422-MINI/OP Jumper Einstellungen/ jumper settings Rote/red Jumper : Abschlusswiderstand/ Termination resistors Rote Jumper (Zuschaltbare Red jumper (Optional resistors Abschlusswiderstände) for bus termination) Bei einem RS-422-Bus erfolgt im In general, both ends of a RS-422 Allgemeinen die Terminierung wie bus have to be terminated similar beim RS-485-Bus.
Need help?
Do you have a question about the USB-Mini Series and is the answer not in the manual?
Questions and answers