Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Evolabel T43
- Page 1 USER MANUAL Models: D43 / T43 / T63...
- Page 2 SAFETY To make the work environment as safe as possible, follow the instructions, possible laws and regulations and respect the protection, signs and decals that are mounted on or near the machine. Use and service the system with care. Each user or operator is responsible to ensure that the safety instruction is followed when using the system. CAREFULLY READ THE FOLLOWING SAFETY INSTRUCTION •...
- Page 3 4 - Status beacon 5 - Outer paper guide 6 - Rewinder paper pinch 7 - Rewinder pinch release 8 - Rewind unit T43/ T63 9 - Ribbon rewind shaft 10 - Ribbon unwind shaft D43/ T43/ T63 11 - Power switch...
-
Page 4: Touch Panel
OVERVIEW TOUCH PANEL 1 - Start / Stop button 2 - Active message button 3 - Menu bar 4 - Layout preview 5 - Test print button 6 - Active messages popup window 7 - Reset button CONTROL PANEL 1 - Test print button 2 - Reset button 3 - Stop button 4 - Start button... -
Page 5: Operation
OPERATION CHANGING LABELS... - Page 6 OPERATION...
-
Page 7: Changing Labels
CHANGING LABELS 40cm... - Page 8 OPERATION...
- Page 9 CHANGING LABELS...
- Page 10 OPERATION CHANGING RIBBON (T43/T63) CHANGING LABELS Step 1-5...
-
Page 11: Changing Ribbon
CHANGING RIBBON... - Page 12 OPERATION CHANGING RIBBON Always use a bobbin between the ribbon and the ribbon rewind shaft CHANGING LABELS Step 6-17 LABEL WIDTH SETTING 3 4 5 6 8 9 10 1 2...
- Page 13 LABEL WIDTH SETTING 11cm+0mm=110mm...
- Page 14 OPERATION RIBBON WIDTH SETTING (T43 / T63) 11cm+0mm=110mm LABEL LENGTH SETTING (BLOW APPLICATOR) blow 60mm label lenght (mm) 100 90 70 60...
- Page 15 CLEANING CLEANING PRINT HEAD AND PRINT ROLLER Isopropyl alcohol Paper tissue or cloth (clean and soft) Isopropyl alcohol Paper tissue or cloth (clean and soft) * PLEASE READ THE SAFETY INSTRUCTIONS BEFORE USE!
-
Page 16: Basic Troubleshooting
BASIC TROUBLESHOOTING TEXT ON LABEL BAD QUALITY / STRIPES - Verify that correct label quality and correct ribbon quality 1 2 3 4 5 6 is used. - Clean the print head (see CLEANING) If not OK, contact your service engineer to replace the print head TEXT WRONG POSITIONED ON LABEL (WIDTH) - Check that correct label size is used for the print job...
Need help?
Do you have a question about the T43 and is the answer not in the manual?
Questions and answers