Advertisement
To use the HI-TEMP ALARM for a spa/hot tub, the probe must be installed in the
filter circulation system on the suction side of the pump. If the system is valved for the
skimmer and main drain, be sure to use the main drain pipe or after the two lines are teed
together.
The probe is installed in a well. ( Not supplied with alarm) The well is installed in the
run of the tee, bushing down to 1/2 inch F.I.P.
Note:
If display reads 3.XX(X=any number), wire leads on Terminals #3 and #4 are
reversed.
120v. (red & black)
240v. (red & red)
JENISSE LEISURE PRODUCTS, INC.
blue
relay
5 Van Duyne Court
TOWACO, NJ 07082
Phone: 973/331-1177
c.5/1/2001
t
o
power
display
Control
Circuit
To probe
1 2 3 4 5 6 7
Fax: 973/331-1136
Advertisement
